Analytical Sciences
Online ISSN : 1348-2246
Print ISSN : 0910-6340
ISSN-L : 0910-6340
Original Papers
Solid-Phase Extraction Spectrophotometric Determination of Total Antioxidant Capacity in Antioxidant-poor Samples by Using the Ferric-Ferrozine Method
Kadriye Isil BERKERDilek OZYURTBirsen DEMIRATAResat APAK
Author information
JOURNAL FREE ACCESS
Supplementary material

2017 Volume 33 Issue 6 Pages 683-689

Details
Abstract

Ferrozine (FZ) preferentially stabilizes Fe(II) over Fe(III) to raise the ferric reduction potential and oxidize antioxidants. The advantages of the ferric-ferrozine method over other iron-based total antioxidant capacity assays were: (i) higher molar absorptivity and enhanced sensitivity, (ii) lower interference from foreign ions, (iii) wide pH tolerance (iv) additivity of the absorbances for mixtures. Solid-phase extraction (SPE) could be combined with spectrophotometry, because the magenta-colored anionic Fe(II)-FZ complex was quantitatively sorbed on Sephadex QAE A-25 resin. The sensitivity enhancement using the resin enabled us to conduct total antioxidant capacity (TAC) measurements of antioxidant-poor samples. The apparent molar absorptivity, linear concentration range and trolox equivalent antioxidant capacities (TEAC) of certain antioxidants were found. The calibration curves (lines) of trolox, rutin, and rosmarinic acid individually and in herbal infusions—by using the method of standard additions—were parallel, confirming that the added antioxidants did not interact with herbal constituents to cause chemical deviations from Beer’s law.

  Fullsize Image
Content from these authors
© 2017 by The Japan Society for Analytical Chemistry
Previous article Next article
feedback
Top