Analytical Sciences
Online ISSN : 1348-2246
Print ISSN : 0910-6340
ISSN-L : 0910-6340
Selective Peak Enhancement and Suppression in Conductometric Ion Chromatography and Its Application to the Determination of Trace Levels of Orthophosphate in Environmental Samples
Kazuichi HAYAKAWAAkio KATOAtsushi YAMAMOTOMotoichi MIYAZAKI
Author information
JOURNAL FREE ACCESS

1992 Volume 8 Issue 1 Pages 25-29

Details
Abstract

In non-suppressed conductometric ion chromatography, when a carboxylic acid eluent of low pH is used, the signal intensity (ΔHc) is proportional to the sum of the conductivity change caused by changes in the sample concentration (ΔCs) as well as conductivity changes caused by changes in the eluent concentration (ΔCe). This can be expressed as ΔHC=B(ΔCs)+B(ΔCe), where B is a constant. In this equation, ΔCs is constant for any sample species. However, ΔCe varies with changes in the sample capacity factors. This value is positive when the sample elutes before the system peak (ks<ke), and is negative when it elutes after the system peak (ks>ke). Therefore, the sample peak intensity (ΔHC) is enhanced prior to the system peak and is suppressed after it. These effects increase the closer the sample and the system peaks. The effect of this theory was proved by a determination of orthophosphate using a TSK gel IC-Anion-PW column and a 0.75mM phthalic acid eluent. The detection limit of this method for orthophosphate (1×10-11mol, with an S/N of three) was smaller (by a factor of 10-30) than those by previous conventional ion chromatographic methods. Also, the interference of chloride or nitrate, often observed in the previous methods, was removed by suppressing their peak intensities. When this method was applied for the determination of orthophosphate in environmental samples, other interfering compounds were effectively removed by a column-switching system attached to the ion chromatograph, and a trace level of the orthophosphate was determined.

Content from these authors
© The Japan Society for Analytical Chemistry
Previous article Next article
feedback
Top