Durability of Pt/Graphitized Carbon Catalyst Prepared by the Nanocapsule Method for the Start/Stop Operating Condition of Polymer Electrolyte Fuel Cells

抄録

The objective of this research was to assess the feasibility of the use of highly corrosion resistant graphitized carbon (GC) as a support for Pt nanoparticles in polymer electrolyte fuel cells and to assess the role of the state of Pt dispersion in the maintenance of performance. Three types of 50 wt% Pt-loaded catalysts (commercial Pt/CB, Pt/GC and an in-house-prepared nanocapsule Pt/GC) were subjected to durability testing by means of a standard voltage step protocol (0.9 V↔1.3 V vs. RHE, holding 30 s at each voltage, 1 min for one cycle) at 65°C with H₂ (anode) and N₂ (cathode), and ambient pressure (0.1 MPa). The durability was estimated on the basis of either 3000 potential cycles (commercial Pt/CB) or 10000 cycles (commercial Pt/GC and nanocapsule Pt/GC). The current-voltage curves were measured initially and after certain numbers of cycles N at 65°C, 100% RH with H₂ and air. The electrochemically active surface area (ECA) decreased with increasing N, particularly the commercial Pt/CB, which underwent severe degradation in the cathode. In contrast, commercial Pt/GC and nanocapsule Pt/GC showed slow ECA degradation, due to the high corrosion resistance of GC. Furthermore, it was found that the decrease in cell performance was smaller for the nanocapsule Pt/GC compared to that for the commercial Pt/GC by 10 to 50 mV, because the Pt nanoparticles of the nanocapsule Pt/GC were well dispersed over the whole GC surface. We also examined the changes in the state of dispersion of the Pt nanoparticles by use of transmission electron microscopy (TEM).