Article ID: ISIJINT-2019-718
In recent years, to improve the fuel efficiency of automobiles by reducing their weight while maintaining their strength, smaller-thickness and higher-strength steel sheets tends to be used as automobiles' construction materials. For stable and accurate production of these sheets, it is crucial for them to be flattened through the hot strip rolling process. Therefore, to realize accurate automatic flatness control (AFC), a new shape meter that employed the light-emitting diode (LED) dot pattern projection method was developed. This consists of an LED dot pattern projector that can project the staggered periodic dot pattern, made of 1200 power LED chips, on the rolled strip and area camera that captures the image of the projected pattern. Then, instantaneous strip flatness is measured to analyze the pattern pitch correlative with inclination angle. The shape meter was installed at the hot strip finishing mill's exit, and its measurement accuracy and stability were evaluated. As a result, its inclination angle measurement error was within 0.45 degrees (two sigma) when compared to the set angle of the standard target, and the measured flatness of the rolling strip was consistent with the visually observed one. Its measurement success rate per entire coil was above 98.5%. These results indicated that the developed shape meter could be applied to the AFC. In addition, applying the measured flatness to the AFC of the work roll bender and leveling, it was confirmed that the strip flatness was improved in a short time.
