ISIJ International
Online ISSN : 1347-5460
Print ISSN : 0915-1559
ISSN-L : 0915-1559
Strip Quality of Highly Alloyed Metals by Twin Roll Casting
Shigeru MiyakeHiroshi YamaneMasao YukumotoMichiharu Ozawa
Author information
JOURNALS FREE ACCESS

1991 Volume 31 Issue 7 Pages 689-695

Details
Abstract

The commercial success of twin roll casting, like of other strip castings, depends, largely upon the quality of its cast products. For quality improvement, various aspects of twin roll casting have been investigated. An on-line measurement of flow rate and strip thickness has proved that the charge of strip thickness at width center is proportional to the change of flow rate. A TV monitor system has shown that the pool surface on the cooling rolls repeats fluctuation of ±4mm due to melt feeding and roll rotation, causing the strip thickness variation of ±7%. Casting with different roll-sleeve thicknesses has shown that thinner sleeves produce convex strip and thicker sleeves produce concave strip. Strip temperature observation at the coiling stage has indicated that precipitation of σ phase makes austenitic stainless steels quite brittle.
A sliding gate nozzle has been introduced to control the flow rate; cooling rolls with complicated sleeve profiles have been devised to control the roll crown; a secondary cooling with water jets has been applied to prevent σ phase precipitation. Consequently, stainless steels or Ni base alloys are being cast into commercial grades of overlay welding hoops.

Information related to the author
© The Iron and Steel Institute of Japan
Previous article Next article
feedback
Top