ISIJ International
Online ISSN : 1347-5460
Print ISSN : 0915-1559
ISSN-L : 0915-1559
Mathematical Analysis and Numerical Simulation of High Frequency Electromagnetic Field in Soft Contact Continuous Casting Mold
Xianzhao NaXingzhong ZhangYong Gan
Author information

2002 Volume 42 Issue 9 Pages 974-981


The electromagnetic parameters in soft contact continuous casting billet mold were analyzed in this paper by mathematical analytic method and numerical simulation; the optimized frequency range was fixed on 20 000-40 000 Hz. The distribution of magnetic flux density and electromagnetic body force in split mold was obtained; the research results achieved respectively by mathematical analytic method and numerical simulation agree with each other. With increase of frequency of electromagnetic field, the electromagnetic body forces acted on the surface of strand increase, and attenuate rapidly towards the center of strand. When the meniscus was located at the middle of coil height, the electromagnetic body force acted on it is biggest, and then decreased along the casting direction to almost zero at the location of charge bottom. On the transverse direction perpendicular to the casting direction, the asymmetrical distribution of magnetic field at the surface of strand permeated through the slit of mold was enhanced slightly with the increase of frequency. The magnetic flux density at the slit area is about 10% higher than that at other area at 40 000 Hz, and the distribution of magnetic body force is almost even on this direction.

Information related to the author
© The Iron and Steel Institute of Japan
Previous article Next article