JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
Print ISSN : 0021-9592
Materials Engineering and Interfacial Phenomena
Preparation of Copper Fine Particles by a Wet Chemical Method
Takahiro KatoYuri TakadaHirokazu OkawaKatsuyasu Sugawara
Author information
JOURNAL RESTRICTED ACCESS

2021 Volume 54 Issue 3 Pages 103-109

Details
Abstract

Copper fine particles were prepared by a wet chemical method using copper sulfate as a starting material, hydrazine as a reducing agent, and sodium hydroxide as a pH adjuster. It was found that there was a branch point at which the precursor changed to copper hydroxide (Cu(OH)2) or copper oxide (CuO), depending on the sodium hydroxide/copper sulfate molar ratio, and a range in which the particle size of the metallic copper fine particles was minimum. At higher concentrations and feeding rates of the hydrazine solution, smaller copper particles were obtained. Copper particles with a size of 0.14–2.4 µm were obtained at a sodium hydroxide/copper sulfate molar ratio of 0.9–4.9, hydrazine concentration of 2.02–20.2 mol/L, and hydrazine feeding rate of 0.5–1.0 mL/min.

Information related to the author
© 2021 The Society of Chemical Engineers, Japan
Previous article Next article
feedback
Top