Journal of the Ceramic Society of Japan
Feature: Microstructural Design and Control of Ceramics through Sintering: Full papers
A comparative study of different sintering models for Al2O3
Chung VAN NGUYENSree Koundinya SISTLAStanley VAN KEMPENNgoc Anh GIANGAlexander BEZOLDChristoph BROECKMANNFriederike LANGE
著者情報
ジャーナル フリー

124 巻 (2016) 4 号 p. 301-312

詳細
PDFをダウンロード (2487K) 発行機関連絡先
抄録

Based on various deformation mechanisms occurring during solid state sintering (pressureless and pressure assisted), a multitude of sintering models have been developed and presented in literature. As reported in literature, most of the simulation results line up well with experimental data. Unfortunately, none of them can be used arbitrarily and none of them are applicable to a generalized case. This paper focuses on a comparative study of three commonly applied models. The first model is based on a physical approach (Riedel) and the other two are phenomenologically based models (the modified Skorohod–Olevsky Viscous Sintering (SOVS) model and a modified Abouaf model). The material models have been implemented through FORTRAN Subroutines used for the FE-Software ABAQUS. The simulation results demonstrate their advantages and disadvantages based on sintering simulations of an aluminum oxide based ceramic cylinder and a bilayer laminate. A guideline to select a suitable model and the adjustment of input parameters under different sintering conditions for general usage is also discussed.

著者関連情報
© 2016 The Ceramic Society of Japan
前の記事 次の記事
feedback
Top