低温工学
Online ISSN : 1880-0408
Print ISSN : 0389-2441
ISSN-L : 0389-2441
三層構造Nb-Ti超電導線の直流臨界電流試験方法の標準化への提案
久保 芳生小川 陸郎高尾 智明福井 聡塚本 修巳長村 光造
著者情報
ジャーナル フリー

2002 年 37 巻 12 号 p. 765-774

詳細
抄録

To standardize the test method for the critical current (Ic) measurement of three-component (Nb-Ti/Cu-Ni/Cu) superconducting wires, we have extracted many problems such as quenching, which often occurs in the wires, and have established a new measuring method. It was found that adding tension corresponding to a 0.1-0.2% strain applied to the wires is effective for preventing quenching than using silicone grease for fixing the wires to a mandrel, and that we can measure Ic's for all magnetic fields without quenching by soldering the wire to an alloy mandrel. It was also found that no trouble occurs when common Cu/Nb-Ti wires are measured based on the Ic test method of three-component wires. Therefore it is favorable to fix the wires by tension rather than using silicone grease in the case of wires which are easily quenched. Round robbin tests were carried out to check the validity of the draft for the test method. As a result of checking the coefficients of variation (COV) concerning individual experimental results, it was confirmed that the COV's reduce less than 2% in most cases. Based on these results, the draft of a test method for three-component wires was prepared.

著者関連情報
© 社団法人低温工学協会
前の記事 次の記事
feedback
Top