抄録
A comparison between the shapes of the sleeve cap lines of several basic patterns and developed curves of model sleeves is attempted. The model sleeves are made to match arbitrarily chosen shapes of arm holes of basic patterns.
The results are :
1) The sleeve cap lines of basic patterns are based on plane development of diagonally cut cylinders.
2) By this simulation, it is found that 4 out of 20 sleeve patterns have the 3-dimensional shapes of the sleeves which correspond to the model sleeve cap lines.
Therefore, by using this simulation and given the shape of the arm hole and the angle between the limb and the side of a sleeve pattern arbitrarily, the sleeve cap lines which have similar configurations as these 4 patterns can be obtained.
