JOURNAL OF THE MARINE ENGINEERING SOCIETY IN JAPAN
Online ISSN : 1884-4758
Print ISSN : 0388-3051
ISSN-L : 0388-3051
A Model for Lubricant Stress in Modern Medium Speed Diesel Engines and its Verification in a Wärtsilä 4L20 Laboratory Engine
—Part 1—
J. HengeveldM.J. CannonM.J. Scheele
Author information
JOURNAL FREE ACCESS

1999 Volume 34 Issue 5 Pages 340-348

Details
Abstract

This paper was voted best diesel paper at the 22nd CIMAC Congress, May 1998.
Engine manufactures promote medium speed trunk piston engine designs equipped with flame rings on the basis of less bore polish and controlled, low oil consumption as a direct consequence of the virtual elimination of piston crown land deposits.
A model of the influence of oil consumption and oil charge on oil stress factors has been used to illustrate the increase in oil stress when such modern designs are introduced.The oil degradation as predicted by the model is compared with actual practices using as an example parameter the BN depletion rate. Results from the full scale Wärtsilä 4L20 laboratory engine shed light on the actual BN degradation process and the effect different oil chemistries have. Also the operating environment for acceptable equilibrium oil conditions-at which no oil change would be required-is analysed in detail and it is calculated that a minimum oil consumption of 0.5 g/kWh is required, in line with current recommendations by major engine manufacturers.
In addition, the test results reveal to what extent critical engine condition parameters like piston under crown cleanliness and fuel pump plunger sticking are affected not only by different levels of oil stress, but also by variations of oil chemistry.
Finally, the data generated in the controlled laboratory environment are shown to be consistent with information from service experience and may thus be used with confidence to guide selection of commercial lubricants.

Content from these authors
© Copyright Clearance Center,Inc.
Previous article
feedback
Top