Journal of the Japan Institute of Metals and Materials
Online ISSN : 1880-6880
Print ISSN : 0021-4876
ISSN-L : 0021-4876
Regular Article
Characterization of Polycrystalline Tungsten Surfaces Irradiated with Nitrogen Ions by X-ray Photoelectron Spectroscopy
Yoshitomo Kamiura Kenji UmezawaYuden TeraokaAkitaka Yoshigoe
Author information
JOURNAL FREE ACCESS FULL-TEXT HTML

2017 Volume 81 Issue 11 Pages 510-515

Details
Abstract

Polycrystalline tungsten surfaces were irradiated at room temperature with two kinds of nitrogen ions—N+ and N2+—at 2.5 keV by using an ion beam apparatus. Results of X-ray photoelectron spectroscopy (XPS) experiments performed using synchrotron radiation at SPring-8 showed that upon irradiation of the tungsten sample with either kind of ion, the full widths at half maximum (FWHM) of the W 4f7/2 and W 4f5/2 peaks broadened and the peaks at 35.8 eV and 37.8 eV—which correspond to WO3 binding energies—increased slightly; this indicated the formation of tungsten nitride at the subsurface below the interface. The N 1s spectra of tungsten after nitrogen ion beam irradiation were decomposed into four component peaks. The positions of these component peaks were observed to be the same as those of the standard tungsten oxynitride W0.62(N0.62O0.38), which exhibited W2N peaks in X-ray diffraction analysis. The main decomposed peaks at 397.3 eV and 398.1 eV were attributed to W-N bonds and W-N-O bonds, respectively. The variation of the intensity ratio of the N 1s peak at 397.3 eV to the W 4f doublet peaks (corresponding to W-N bonds) as a function of the escape depth, which was measured by angle-resolved XPS, apparently followed a normal distribution for the irradiated samples. This indicates that the W-N bond density of the tungsten surface irradiated with N2+ ions is higher than that of the surface irradiated with N+ ions and also that the N2+ ions penetrate slightly deeper than the N+ ions.

 

Mater. Trans. 57(2016) 1609-1614に掲載

Content from these authors
© 2017 The Japan Institute of Metals and Materials
Previous article Next article
feedback
Top