2017 Volume 65 Issue 1 Pages 1-9
The pintle injector is a promising candidate for injection systems of future rocket engines because of the throttling capability, the combustion stability, and the low manufacturing cost. Few studies focusing on fundamental aspects of a pintle injector have been conducted, and most of the design parameters of a pintle injector is determined mainly based on the empirical knowledge. Among the design parameters, total momentum ratio (TMR) is one of the most important parameters since spray structure is dominated by TMR. Therefore, combustion experiments using an ethanol/liquid oxygen rocket engine combustor with a planar pintle-type injector which is designed for optical measurements for a pintle injector are conducted at combustion pressure (Pc) = 0.37-0.42MPa, mixture ratio (O/F) = 1.31-1.49, TMR = 0.32-3.65 to investigate the effects of propellant momentum ratio on the combustion behavior. The spray structure under hot fire conditions is observed using high-speed imaging techniques with a backlit configuration. In the oxidizer-centered configuration, the characteristic exhaust velocity efficiency (ηC*) decreases with the increase of the TMR. The atomized propellant impinge on the combustor wall before the vaporization and reaction at higher TMR. In the fuel-centered configuration, though the propellant spray is more inclined to the direction of the upper combustor wall at higher TMR, the ηC* does not change with the TMR. In both oxidizer-centered and fuel-centered, higher ηC* is provided in the condition of higher injection pressure drop.
