精密工学会誌
Online ISSN : 1882-675X
Print ISSN : 0912-0289
ISSN-L : 0912-0289
論文
エンドミル加工における外乱オブザーバを用いたセンサレスびびり振動検出技術の開発 (第1報)
—平均計時法を用いた高精度プロセスモニタリング—
周藤 唯柿沼 康弘大西 公平青山 藤詞郎
著者情報
ジャーナル フリー

2011 年 77 巻 7 号 p. 707-712

詳細
抄録

This paper presents a sensor-less process monitoring method to detect chatter vibration in square end milling. The method of monitoring cutting forces and detecting chatter vibration using external sensors such as accelerometer and force sensor has been proposed. However, using external sensors increases the cost of manufacturing systems and additional structures for sensor implementation often decrease the stiffness of workpiece fixturing, and it results in another chatter vibration. Therefore, a novel method without using any external sensors is developed to detect high-frequency vibration. Concretely, disturbance torque acting on the spindle is estimated by using disturbance observer and used simultaneously for spectrum analysis. From the experimental results, it is confirmed that the proposed method enables to estimate high-frequency disturbance. Certain peaks which are considered as a peak frequency of chatter vibration can be detected.

著者関連情報
© 2011 公益社団法人 精密工学会
前の記事 次の記事
feedback
Top