高周波振動する模型単粒による微小切削について

高周波振動砥石による超仕上の基礎研究

抄録

The present paper describes on the vibration small depth cutting performed by one model grain for the purpose of analysing the performances of high frequency vibration finishing. In this study, the characteristic phenomena that the grain passes over again the groove already cut and cuts the rising part which was built up at the both sides of groove were analysed, then the cutting resistance and the wear of model grain were measured.
From the analysis about a cutting locus and the experimental results, we can explain the removed volume of work piece and the loss of stone in the high frequency vibration superfinishing and obtain a guide to determine the optimum conditions.