精密工学会誌
Online ISSN : 1882-675X
Print ISSN : 0912-0289
ISSN-L : 0912-0289
ステンレス鋼の研削におけるCBNホイールの目づまり現象
幸島 和彦鬼鞍 宏猷佐久間 敬三
著者情報
ジャーナル フリー

1992 年 58 巻 7 号 p. 1209-1214

詳細
抄録

This paper describes the phenomenon of loading on an active surface of a CBN wheel in grinding austenitic stainless steel (SUS304). The influences of bond systems, depths of cut and grinding method (up and/or down cut) on the loading of CBN wheels are examined in detail by measuring the loaded areas, wheel wears and grinding forces. The conclusions are summarized as follows; (1) The loaded area ratio (loaded area / active surface area) on the vitrified bonded CBN wheel is larger than that on the resin bonded CBN wheel, and the mean area per piece of the loading on vitrified bonded CBN wheel is about 7 times as large as that on resin bonded CBN wheel. (2) Decreasing depth of cut results in a decrease in loading. (3) The loading on vitrified bonded CBN wheel develops more rapidly than that on resin bonded CBN wheel. They are found to be dislodged if loaded areas exceed the limit area (about 0.14mm2). (4) The loading of CBN wheels in up cut grinding is less than that in down cut grinding.

著者関連情報
© 社団法人 精密工学会
前の記事 次の記事
feedback
Top