2020 Volume 69 Issue 1 Pages 73-82
The physicochemical and sunscreen properties of marl as a function of particle size were investigated. The research findings established that the marl under investigation consisted of more than 95% calcium carbonate (CaCO3). The particles of marl inspected under a scanning electron microscope were calcite, which is the stable polymorph of CaCO3, with a rhombohedral structure. The particle size classification by the sieving method showed that grinding using a ball mill could downsize the marl particles by 2 to 3 times, reaching below 15 µm on average. Marl particles showed a tendency to reflect ultraviolet A (UVA) rays rather than UVB rays and a possibility to steadily absorb both UVAII and UVAI. Finer particles obtained after a longer grinding process demonstrated higher efficacy regarding UV reflection and absorption properties. The 3 wt.% marl displayed a sun protection factor (SPF) value of 1 to 2. However, marl demonstrated a good ability to protect against radiation over a broad spectrum range with a critical wavelength above 370 nm. The addition of marl in the formulation containing avobenzone and octinoxate had a positive synergistic effect because the marl was able to increase the UV absorbance efficacy (based on the area under the curve (AUC) value) and SPF value of the cream. Furthermore, it was also discovered that the added marl powder could slow the decrease in UV protection efficacy of the products in terms of the AUC calculated from the absorbance profile after exposure to simulated UV rays with an amplitude range of 10 J/cm2 to 40 J/cm2 for 30 min, which was similar to the results obtained from octocrylene and bemotrizinol.
