機械材料・材料加工技術講演会講演論文集
Online ISSN : 2424-287X
セッションID: 206
会議情報

局所摩擦加熱により作製されたオープンセル型ポーラス金属-樹脂板接合体の接合強度と圧縮特性
松本 良阪口 晴崇大津 雅亮宇都宮 裕
著者情報
会議録・要旨集 認証あり

詳細
抄録

An open-cell nickel foam was joined with a polymethyl methacrylate (PMMA) sheet with a thickness of 1.0 mm by friction stir incremental forming (FSIF) process under rotation rate of the tool faster than 2000 rpm and feed rate of the tool slower than 60 mm/min. The joining strength between the foam and the sheet was obtained over the fracture strength of the foam in uniaxial tensile test. On the other hand, the compressive specific strength of the foam–sheet composite was obtained approximately 33 times higher than that of the foam in uniaxial compression test. This was due to not only high specific strength of the sheet but also sandwich structure of the foam–sheet composite.

著者関連情報
© 2020 一般社団法人 日本機械学会
前の記事 次の記事
feedback
Top