材料
Online ISSN : 1880-7488
Print ISSN : 0514-5163
ISSN-L : 0514-5163
18-8ステンレス鋼の高温ねじりクリープ強度に関する研究 (第4報)
18-8Cbステンレス鋼のねじりクリープ強度に及ぼすねじり加工温度の影響
上田 太郎松尾 哲夫
著者情報
ジャーナル フリー

1963 年 12 巻 112 号 p. 59-64

詳細
抄録

In the last paper, authors reported that the torsional working temperature has a remarkable influence on the torsional creep limit of a plain 18-8 stainless steel. Through the present investigation, measurement of torsional creep limit of a 18-8 Cb Stainless steel bar (5mmφ×50mm) austenized and twisted to a degree of 0.128π/cm or 0.256π/cm was made at 500 and 600°C, and then hardness and micrographic testing and X-ray analysis were carried out. These results obtained are summalized as follows:
Torsional creep limit of a 18-8 Cb stainless steel is not so much affected by the torsional working temperature of -60∼800°C as in case of the creep limit of plain 18-8 stainless steel.
In this 18-8 Cb stainless steel, it was found that the effects of torsional working temperature on the difference of the hardness before and after creep testing and also on the precipitation mode of Cb-carbide (CbC) were small.

著者関連情報
© 日本材料学会
前の記事
feedback
Top