材料
Online ISSN : 1880-7488
Print ISSN : 0514-5163
ISSN-L : 0514-5163
FBR用溶接継手の高温低サイクル疲労,クリープおよびクリープ疲労強度評価例
野中 勇北川 正樹大友 暁和田 雄作
著者情報
ジャーナル フリー

1986 年 35 巻 390 号 p. 299-304

詳細
抄録

To establish an evaluation method of elevated temperature strength for weldments, a series of investigations1)-5) had been performed on the low-cycle fatigue strength. In this study, the suitable evaluation methods of creep and creep-fatigue strengths for weldments were proposed and were applied to the life prediction of FBR weldments.
The following results were obtained.
(1) In the evaluation of low-cycle fatigue strength for the weldments, the accuracy of life prediction by the Method (I), Method (II) and FEM was determined mainly by the difference in cyclic deformation resistance between the base metal and the weld metal. The Method (I), Method (II) and FEM were effective for the weldments which have small difference in cyclic deformation resistance such as stainless steel and 21/4 Cr-1 Mo steel with PWHT. But for the weldments which have large difference in cyclic deformation resistance such as the 21/4 Cr-1 Mo steel without PWHT, the Method (I) predicted the life overconservatively and FEM overestimated the life inversely.
(2) In the evaluation of creep strength for the weldments, the minimum creep strain rate of the 21/4 Cr-1 Mo steel weldment was predicted by the Independent Method which paid attention to only the weakest part of the weldment and also by the Interaction Method which considered the interaction between the base metal and the weld metal. Both of them were found to be effective for the 21/4 Cr-1 Mo steel weldments.
(3) In the evaluation of creep-fatigue strength for the weldments, a new method was proposed which was an extension of the fatigue evaluation method (I) based on the linear damage summation rule. It could predict the life of the 21/4 Cr-1 Mo steel weldments within a factor of two on life.

著者関連情報
© 日本材料学会
前の記事 次の記事
feedback
Top