日本口腔インプラント学会誌
Online ISSN : 2187-9117
Print ISSN : 0914-6695
原著
商業用純チタンとTi-6Al-4V合金を組み合わせたインプラントへの荷重負荷とひずみとの関係
中村 秀範佐野 哲也加藤 良一吉田 貴光伊藤 充雄
著者情報
ジャーナル フリー

29 巻 (2016) 4 号 p. 236-242

詳細
PDFをダウンロード (1058K) 発行機関連絡先
抄録

Implant bodies and abutments produced using G4 and G5 were connected in combination. In each combined implant body and abutment, a strain gauge was attached to the most superior area of the test piece in the area of the collar. The strain in each strain gauge-attached test piece was measured in a universal testing machine at an inclination angle of 30°. The influence of the combination of test piece produced using G4 and G5 on the measured strain was evaluated, and the following conclusions were obtained. Although the maximum bending load for the abutment screw was larger with G5 than with G4, the amount of deflection of the abutment screw up to the maximum bending load showed no significant difference between G4 and G5. Up to loading of 450 N, no significant differences in the amount of strain were observed among any of the combinations of implant body and abutment. However, at a load of 500 N and above, the amount of strain in combined implant bodies and abutments showed that the amount of strain was lower with G5G5 than with G4G4 and G4G5. Therefore, it was suggested that the strain was reduced by improving the strength of the collar part of the implant.

著者関連情報
© 2016 公益社団法人日本口腔インプラント学会
前の記事 次の記事

閲覧履歴
feedback
Top