Online ISSN : 1347-5320
Print ISSN : 1345-9678
ISSN-L : 1345-9678
Filtering of Acoustic Emission Signals for the Accurate Identification of Fracture Mechanisms in Bending Tests
Eva Martinez-GonzalezIngrid PicasJordi RomeuDaniel Casellas
Author information

2013 Volume 54 Issue 7 Pages 1087-1094


In this manuscript, acoustic emission (AE) analysis is used to identify the fracture mechanisms that take place during a three-point bending test of steel specimens. However, an important source of AE was detected and related to the deformation of the supports and the surface of the steel specimen in contact. This source creates AE signals that are very high in number and amplitude, and prevent determining accurately the onset stress for fracture mechanisms in specimens. A signal filtering is proposed based on the properties of the initial part of the recorded AE waveform, combined with a linear localization. The filtering successfully allows the AE signals to be classified according to their source as background noise, damage due to contact of the specimen surface to the supports and fracture mechanisms occurring in the specimen microstructure as a result of the bending test. The aforementioned filter has been successfully applied in case of a cold work tool steel DIN 1.2379 to determine accurately the stress level at which the first damaging mechanisms start to occur in the microstructure in situ during the three-point bending test. Filtered AE signal results indicating damage in the microstructure have been corroborated by inspection of the specimen’s surface in a Confocal Microscope. In default of using the proposed filter, unfiltered signals have been estimated to lead to an overestimation of critical stresses of about 20%, what is undesirable for most applications.

Information related to the author
© 2013 The Japan Institute of Metals and Materials
Previous article Next article