MATERIALS TRANSACTIONS
Online ISSN : 1347-5320
Print ISSN : 1345-9678
Influence of Dog-Bone Width on End Profile in Plan View Pattern Control Method in Plate Rolling
Masayuki HorieKenji HirataJunichi TatenoNaoki Nakata
Author information
JOURNALS FREE ACCESS FULL-TEXT HTML

2017 Volume 58 Issue 4 Pages 623-628

Details
Abstract

A plan view pattern control method for plate rolling called the Mizushima Automatic Plan View Pattern Control System (MAS) or Dog Bone Rolling (DBR) was developed. In this method, the slab is given a non-uniform thickness profile in the width direction to obtain non-uniform elongation at following flat rolling. In order to make the plate more rectangular under various rolling conditions, prediction of elongation at following flat rolling is necessary. In this research, the influence of the width of the dog-bone (overly thick part at the slab width edge) on the fish-tail length (over-elongation at the slab end) is investigated. The fish-tail length increases as the dog-bone width increases and the dog-bone width ratio decreases. These phenomena are related to the following behavior of the restriction of excessive elongation in the dog-bone because of existence of unrolled volume before roll gap entrance: As the dog-bone width increases and the dog-bone width ratio decreases, the working length of restricting stress increases. Hence, restricting stress is released earlier and the rolling length for fish-tail formation increases. As a result, the fish-tail length increases. Therefore, in prediction of the plan view pattern, not only the dog-bone thickness, but also the dog-bone width and dog-bone width ratio should be considered.

 

This Paper was Originally Published in Japanese in J. JSTP 57 (2016) 347–352.

Information related to the author
© 2017 The Japan Society for Technology of Plasticity
Previous article Next article
feedback
Top