開発と研究
射出成形の生産工程設計方法の研究
－可塑化装置のパラメータ設計からMTシステムによる解析まで－
2011 年 19 巻 1 号 p. 44-52
詳細
2011 年 19 巻 1 号 p. 44-52
In this study, first a parameter design of the plasticizing unit in an injection molding machine was carried out, and then the relationship between the characteristic values obtained in the experiment and resin melt temperature data was investigated. If the characteristic values correlate to various quality data,variation can be reduced by parameter design first, and then the injection molding production process can be controlled by general injection molding measurements. For rational evaluation in the stages from process design to process control as described above, it is desirable to perform both a parameter design and an analysis and evaluation by the MT (Mahalanobis-Taguchi) system. A rational design method for the MT system, similar to parameter design, was discovered through this study, and an effective method of designing production processes for injection molded products was found.
