塑性と加工
Online ISSN : 1882-0166
Print ISSN : 0038-1586
ISSN-L : 0038-1586
論文
超塑性ダイレス引抜きによるマイクロ異形集合管の創製
古島 剛白崎 篤真鍋 健一
著者情報
ジャーナル フリー

2011 年 52 巻 602 号 p. 380-384

詳細
抄録

A superplastic dieless drawing process that uses no dies or tools is applied to the drawing of a Zn-22Al superplastic alloy for fabricating micro-noncircular tubes such as square, rectangular and noncircular multicore tubes combined with inner square and outer rectangular section tubes. In this study, the effects of heating conditions such as heating length and the use or nonuse of a cooling device on deformation behavior are investigated. As a result, a micro-square tube with a 0.58mm side and a micro-rectangular tube of 0.75×1.3mm were fabricated after 3-pass superplastic dieless drawing. In addition, the fundamental deformation behavior of noncircular tubes combined with square and rectangular tubes during the dieless drawing process has been clarified experimentally. The cross-sectional shape of the noncircular tubes after the superplastic dieless drawing process tends to be maintained on basis of the similarity law in the case of a large heating condition compared with a narrow heating condition. Furthermore, a micro- noncircular tube, which has inner square tubes with a 335μm side, and an outer rectangular tube of 533×923μm were fabricated successfully after a 4-pass superplastic dieless drawing process. Consequently, it is found that superplastic dieless drawing for the fabrication of noncircular multicore tubes is quite effective.

著者関連情報
© 2011 一般社団法人 日本塑性加工学会
前の記事
feedback
Top