塑性と加工
Online ISSN : 1882-0166
Print ISSN : 0038-1586
ISSN-L : 0038-1586
論文
ショットピーニング処理された超硬合金金型の表面性状の特徴と冷間リング圧縮における潤滑特性
松本 良甲斐 信宏富田 雄人梶岡 彰森 章司宇都宮 裕
著者情報
ジャーナル オープンアクセス

2015 年 56 巻 656 号 p. 793-797

詳細
抄録

The characteristics of the surface profile of cemented tungsten carbide dies after either shot peening (SP) or conventional mechanical polishing (MP) surfaces were investigated with a surface roughness tester. The relationship between arithmetic and ten-point mean roughness was almost the same in the MP and SP dies. The mean period of the surface roughness profile of the SP die was approximately 1/3 times shorter that of the MP die. The distribution of the peaks and valleys of the surface profile was symmetric in the SP die, whereas it was skewed toward the peaks in the MP die. The lubrication performance of the MP and SP dies in cold forging of a titanium workpiece was measured by the ring compression test. The SP die with a mirror surface reduced the friction at a high reduction in height range because the die holds liquid lubricant in the micro valleys on its surface during the ring compression test.

著者関連情報
© 2015 一般社団法人 日本塑性加工学会
前の記事 次の記事
feedback
Top