Abstract
Introduction: S2 alar-iliac screw (S2AIS) insertion for lumbosacral fixation is becoming a common procedure for deformity surgeries. However, studies that have reported the anatomy and morphometric features of the pelvis for S2AIS insertion in the Japanese samples are scarce. This study aimed to elucidate the morphometric features of the pelvis regarding S2AIS insertion in the Japanese samples.
Methods: We used 60 computed tomography scans of the pelvis (30 men and 30 women). The entry point for the S2AIS was determined as 1-mm lateral and 1-mm distal to the S1 dorsal sacral foramen. We resliced the plane in which the pelvis was sectioned obliquely from this entry point to the anterior inferior iliac spine in the sagittal plane. We bilaterally placed the shortest and longest virtual S2AISs in this plane using a 4-mm margin. We analyzed the length, angle, and safety of the determined trajectory and compared these measurements according to sex and age.
Results: The median longest and shortest screw lengths were 108.1 and 103.3 mm, respectively. The median longest and shortest distances from the entry point to the sacroiliac joint were 31.2 and 28.2 mm, respectively. The median smallest and largest lateral angulations were 40.7° and 47.3°, respectively. The median angle range was 4.2°. The median caudal angulation was −2.8°. The median shortest and longest distances from the S2AISs to the acetabular roof were 23.5 and 27.4 mm, respectively. The median distance from the S2AISs to the sciatic notch was 23.1 mm. Assuming the insertion of screw with a diameter of 8 mm, S2AIS insertion was difficult in 32 of 120 (27%) screws because the dorsal cortex of the sacrum was damaged.
Conclusions: Screw length and lateral angulation were similar to those in previous studies. Insertion difficulty occurred in 27% of screws.
