抄録
Rolling theory has made remarkable progress for the last 100 years. The history of rolling theory is described in this report, comparing rolling theory with innovation of strip rolling technology. In Japan, computer control system started to be introduced to iron and steel company in 1960s. Therefore, research of rolling theory became indispensable. Before 1960, it was published mainly in Europe and America. It is said that two-dimensional rolling theory had been completed. First of all, in Japan yield stress was investigated to calculate rolling load precisely, and approximate three- dimensional analysis for deformation of rolled strip was researched to predict the distribution of rolling pressure in width direction, which made up crown and flatness of rolled strip. After that, FEM (finite element analysis method) replaced the approximate three-dimensional analysis, by which three-dimensional deformation of rolled strip could be calculated precisely. The results of these researches supported the innovation of crown and flatness control technology and the invention of many rolling mills with high functional ability for crown and flatness control. Next, the continuous strip rolling theory was completed chiefly in Japan, by which the static and dynamic characteristics of tandem strip mills could be understood. It is said that the continuous rolling technology for cold and hot strip tandem mills were not realized without the continuous strip rolling theory.
