鉄と鋼
Online ISSN : 1883-2954
Print ISSN : 0021-1575
計測・制御・システム技術
LEDドットパターン投影法による熱延鋼板平坦度計の開発
伊勢居 良仁加藤 朋也大杉 正洋太田 武
著者情報
ジャーナル フリー HTML

2019 年 105 巻 1 号 p. 20-29

詳細
抄録

In recent years, in order to improve the fuel efficiency of automobiles by reducing their weight with maintaining strength, the thinner thickness and higher strength steel sheets tends to be used as their construction materials. For stable and accurate production of these sheets, it is very important for these to be flattened at hot strip rolling process. Therefore, to realize accurate AFC (Automatic Flatness Control), a new shape meter which employed LED dot pattern projection method was developed. This is consist of LED dot pattern projector which can project the staggered periodic dot pattern, formed of 1200 power LED chips, on the rolled strip and area camera which captures the image of projected pattern. Then, instantaneous strip flatness is measured by analyzing the pattern pitch correlative with inclination angle. The shape meter was installed at the hot strip finishing mill exit and evaluated its measurement accuracy and stability. As a result, its inclination angle measurement error was within 0.45 degrees (two sigma) by comparing with the set angle of standard target and the measured flatness of rolling strip was consistent with the visually observed one. Its measurement success rate per entire coil was exceeded above 98.5%. These results indicated that the developed shape meter would be able to apply to the AFC. In addition, applying the measured flatness to the AFC of the work roll bender and leveling, it was confirmed that the strip flatness was improved in a short time.

Fullsize Image
著者関連情報
© 2019 一般社団法人 日本鉄鋼協会
前の記事 次の記事
feedback
Top