鉄と鋼
Online ISSN : 1883-2954
Print ISSN : 0021-1575
ISSN-L : 0021-1575
高低圧一体型蒸気タービンロータ用新耐熱鋼21/4Cr-Mo-V鋼の開発
辻 一郎松尾 朝春
著者情報
ジャーナル フリー

1990 年 76 巻 7 号 p. 1163-1170

詳細
抄録

To develop a new low alloy steel for high pressure-low pressure mono-block steam turbine rotor, considerable studies have been performed.
The targets of the new low alloy rotor steel development are to have same high temperature strength as those of conventional 1CrMoV steel for high pressure side of rotor, and to have excellent both room temperature strength (Yield strength is higher than 70 kgf/mm2) and fracture toughness (FATT is lower than + 80°C) for low pressure side of rotor.
The effects of alloy composition on mechanical properties and the heat treatment characteristis of low alloy were investigated. As a result, the 21/4 CrMoV steel containing low silicon manufactured by vacuum carbon deoxidization process was found to show the best performance for mono-block steam turbine rotor.
The 21/4 CrMoV steel rotor for mono-block steam turbine was produced by commercial base. Tensile, impact, stress rupture and metallurgical test were conducted on this rotor, and it is confirmed that this rotor has excellent yield strength and impact propertis at low pressure side and good stress rupture strength at high pressure side.

著者関連情報
© 一般社団法人 日本鉄鋼協会
前の記事 次の記事
feedback
Top