石油技術協会誌
Online ISSN : 1881-4131
Print ISSN : 0370-9868
ISSN-L : 0370-9868
24 巻, 6 号
選択された号の論文の6件中1~6を表示しています
  • 出砿坑油田
    関谷 英一
    1959 年 24 巻 6 号 p. 219-234
    発行日: 1959/11/30
    公開日: 2008/06/30
    ジャーナル フリー
    Chuhuangkeng oil field was discovered by cable No. 1 well in 1904 and is the largest oil field in Taiwan. This oil field is producing oil in the Syukoko sandstone formation of Miocene age. There are three principal oil zone. The productive area is 5.5km long and 300-50m wide. It is asymmetric structure and has an anticlinal fault along the anticlinal axis.
    There are 105 wells in this oil field and the cumulative production reached 200, 000 kl.
    1. Divided into the north block, central block and south block by anticlinal fault along the anticlinal axis and 2 cross faults
    2. In the second layer, the well which is on about-150m subsurface contour line in the west wing of the central block is the most productive one.
    3. In the third layer, the wells situated on about-350m subsurface contour line in the west wing of the south block and central block proved to be the most productive wells.
    4. Both of the 2nd and the 3rd layers have possibities of new drilling and deepening.
    5. Examination of anticlinal fault in the north area and exploration of south area pursuant to the differences in thickness are considered inevitable.
  • 石川 洋
    1959 年 24 巻 6 号 p. 235-237
    発行日: 1959/11/30
    公開日: 2008/06/30
    ジャーナル フリー
    On treating water flooding boundary-value problems, it is not safe to make symmetry considerations and conclude the existence of specified streamlines, or, further, to derive specified solutions, if the uniqueness of the solutions has not been ascertained.
    In order to call attention to this, we are going to refer to several examples, but the theoretical discussions are to be treated on another occasion.
  • Kiyomitsu FUJII
    1959 年 24 巻 6 号 p. 238-242
    発行日: 1959/11/30
    公開日: 2008/06/30
    ジャーナル フリー
    油田の開発において最も重要である井戸のスペーシングに関して研究を行い,次のような結論を得た。(1)油屑内における流体の流れの特殊性を考慮し,かつ油層の実際について調査した結果より判断すれば、井戸のスペーシングと油の最終回収量の間には関係がない。(2)井戸のスペーシングに影響を与えるものは,油層の状態,開発方法および経済条件の3つである。したがつて井戸のスペーシングの問題を解く方程式には,必ずこの条件を含まなければならない。(3)井戸よりの石油の累計産出曲線は油層の状態と開発方法の影響をうけるので,この研究では井戸のスペーシングの方程式にこの曲線を使用する。(4)スペーシングの式に経済条件を入れることにより,最も有利な井戸数と産出より生ずる利益とを計算することができる。(5)最も有利な井戸数は掘鑿費,単位時間当りの採油費および採油期間の影響をうける。(6)井戸数が一定な時には、最も有利な採油期間は単位時間当りの採油費の影響をうける。
  • 平川 誠一
    1959 年 24 巻 6 号 p. 243-248
    発行日: 1959/11/30
    公開日: 2008/06/30
    ジャーナル フリー
    The porosity of a reservoir rock is a very important factor in gas and/or oil reservoir analysis.
    This paper describes a simple and accurate method of determining the porosity in the laboratory. This new method which measures porosity and permeability at the same time has many good points, that is, various permeabilities and desities of the sample, rock porosity under wetting condition, and fluid saturation in original state can be determined.
    The results on several sandstones and two tuffs are given, and the sandstone's data obtained by this method appear to agree with those estimated from formation resistivity factor measurements.
  • 香川 貫一
    1959 年 24 巻 6 号 p. 249-255
    発行日: 1959/11/30
    公開日: 2008/06/30
    ジャーナル フリー
  • 上床 国夫
    1959 年 24 巻 6 号 p. 256-272
    発行日: 1959/11/30
    公開日: 2008/06/30
    ジャーナル フリー
feedback
Top