プラズマ・核融合学会誌
Print ISSN : 0918-7928
79 巻, 12 号
選択された号の論文の13件中1~13を表示しています
Rapid Communications
集中講座 「プラズマ物理実験温故知新」
講座 「レーザーアブレーションの物理と応用」
講座 「プラズマ分光入門」
  • 後藤 基志, 村上 泉, 藤本 孝
    2003 年 79 巻 12 号 p. 1287-1296
    発行日: 2003年
    公開日: 2005/09/28
    ジャーナル フリー
    Glow discharges with different gases in the Large Helical Device (LHD) at the National Institute for Fusion Science (NIFS) show different visual colors of the plasma, and these colors are ascribed to different spectra in the UV and visible wavelength range. From the wavelengths of the observed emission lines, these gases are identified as neon, helium, and hydrogen. The emission line intensity is given by the upper level population density of the corresponding transition via the spontaneous transition probability or Einstein's A coefficient. On the assumption of corona equilibrium, relative emission line intensities of neutral helium are estimated for the n = 3 to n = 2 transitions. The results are in gross disagreement with the glow discharge spectrum. For a single pulsed helium discharge in a Pyrex tube, line emissions are intense during the beginning of the pulse and after the pulse [A. Hirabayashi, et al., Phys. Rev. A 37, 77 (1988)]. The population distribution over the n3 D levels is determined for these two emission peaks, and neither of the results agrees with the expectations from corona equilibrium. It is also found that the color of the plasma observed for a main discharge with helium in LHD is drastically different depending on the plasma condition, and never shows a similar color to that in the glow discharge. All these results indicate breakdown of corona equilibrium and demand us deeper considerations.
研究論文
レビュー論文
  • Hideki ZUSHI, Satoshi ITOH, Naoaki YOSHIDA, Kazuaki HANADA, Kazuo NAKA ...
    2003 年 79 巻 12 号 p. 1302-1316
    発行日: 2003年
    公開日: 2005/09/28
    ジャーナル フリー
    Subjects on TRIAM-1M are presented from the viewpoint of plasma physics and reactor technology associated with ‘steady state operation' (SSO). For a future fusion power plant, for burning plasma, complete steady state operation is required. Control of the density under the complicated plasma-wall interaction, non-inductive current start-up, and sustainment of high performance are key areas in the present and future investigations. The following experimental results are reviewed. First, it is shown that the co-deposition of the metallic impurity and oxygen plays an important role in the temporary change in the wall pumping rate, and a model of the co-deposition probability agreed with the observation. It was also noticed that the thermal release of the hydrogen from the plasma-facing components affects the steady state density operation in the ultra long discharge. It was found that enhanced influx of metal impurities from the hotspot affect the steady state operation of the high performance plasma. Second, helium effects on microscopic damage on metals were studied in helium/hydrogen mixture discharges. A large quantity of dislocation loops and dense fine bubbles were observed by means of TEM even for exposure only 125 seconds in duration. From TDS for the specimens, the amount of retained helium was evaluated to be 3.9 × 1020 He/m2. Third, the physics understanding for the enhanced current drive (ECD) mode around the threshold power level progressed from the viewpoint of transition probability. The forward transition frequency from a non-ECD plasma state to the ECD state was precisely determined under fixed LHCD power. Thus, a statistical probability for ECD transition was determined; that is, the transition behavior around the threshold power could be described in a statistical manner. Transition frequency showed a strong power dependence. Fourth, the current ramp-up scenario without using centre solenoid coils was reinvestigated at higher density, and controllability of the current ramp-up rate was studied. The plasma was initiated by ECH (fundamental O-mode at 170 GHz with 200 kW) at B = 6.7 T, and a ramp-up rate below the technical limit of 150 kA/s for ITER could be achieved by choosing LH power. A model to describe the ramp-up is proposed.
feedback
Top