SANGYO EISEIGAKU ZASSHI
Online ISSN : 1349-533X
Print ISSN : 1341-0725
ISSN-L : 1341-0725
Volume 45, Issue 4
Displaying 1-3 of 3 articles from this issue
Original
  • Jun OJIMA
    Article type: Others
    Subject area: Others
    2003 Volume 45 Issue 4 Pages 125-132
    Published: 2003
    Released on J-STAGE: September 10, 2004
    JOURNAL FREE ACCESS
    Recent studies have shown that a reverse flow often occurs in a unidirectional airflow in push-pull ventilation and may transport contaminants from the source into a worker’s breathing zone. The same problem may arise in local exhaust ventilation when the contaminant source is located in the worker’s wake region. In this study, organic solvent work with local exhaust ventilation was duplicated in a laboratory and the details of the reverse flow around the worker’s body produced by the ventilation were experimentally investigated. In order to evaluate the influence of the reverse flow on the exposure of the worker, experiments with a mock-up mannequin (dummy worker) and a local ventilation system which was equipped with an exterior type hood and an enclosure type hood were conducted. The exposure level and the contaminant leakage from the hoods in several conditions were measured by means of a smoke test and tracer gas method. Ethanol vapor was used as a tracer gas. With the exterior type hood, the reverse flow visualized by the smoke was observed in front of the standing dummy worker but could not be observed when the dummy worker was seated. From the tracer gas measurements, it was proved that the exposure due to the reverse flow was not so serious at a capture velocity of >0.4 m/s, but <10 ppm contaminant leakage from the exterior hood had been recognized independently of the capture velocity. With the enclosure type hood, exposure due to the reverse flow could be controlled with a capture velocity of >0.8 m/s. Although the contaminant leakage from the hood due to the reverse flow was not obvious with the enclosure type in any condition, caution should be exercised to prevent exposure when the worker is seated. Regardless of the hood type, the increase in the capture velocity was effective in decreasing exposure due to the reverse flow.
    Download PDF (96K)
Field Studies
  • Naomi MATSUMOTO, Kozo YOKOTA, Yasushi JOHYAMA, Toshiyuki TAKAKURA
    Article type: Others
    Subject area: Others
    2003 Volume 45 Issue 4 Pages 133-138
    Published: 2003
    Released on J-STAGE: September 10, 2004
    JOURNAL FREE ACCESS
    Epoxy resins are widely used in adhesives, coatings, materials for molds and composites, and encapsulation. Acid anhydrides such as methyltetrahydrophthalic anhydride are being used as curing agents for epoxy resins. The anhydride hardeners are well-known industrial inhalant allergens, inducing predominantly type I allergies. In the electronic components industry, these substances have been consumed in large quantities. Therefore, safe use in the industry demands control of the levels of exposure causing allergic diseases in the workshop. We conducted a prospective survey of two electronics plants to clarify how to control the atmospheric level of the anhydrides in the work environment. Measurements of the levels of the anhydrides in air started according to the Working Environment Measurement Standards (Ministry of Labour Notification No. 46, 1976) in April 2000, along with improvements in the work environment. A value of 40 μg/m3 was adopted as the administrative control level to judge the propriety of the working environment control. A total of 2 unit work areas in both plants belonged to Control Class III. The exposure originated from manual loading, casting, uncured hot resins, and leaks in an impregnating-machine or curing ovens. In order to achieve the working environment control, complete enclosure of the source, installation of local exhaust ventilation, and improvement or maintenance of the local exhaust ventilation system were performed on the basis of the results of the working environment measurement, with the result that the work environment was improved (Control Class I). It became evident that these measures were effective just like other noxious substances.
    Download PDF (92K)
  • Masahiko SAITO
    Article type: Others
    Subject area: Others
    2003 Volume 45 Issue 4 Pages 139-143
    Published: 2003
    Released on J-STAGE: September 10, 2004
    JOURNAL FREE ACCESS
    Although occult urinary blood in health examinations is common in healthy employees, in the majority with occult urinary blood usually no further examination or treatment is necessary, but occult urinary blood could be an early symptom in urinary tract malignancy. In this study the data on health examinations of male employees with occult urinary blood were analyzed from 1999 to 2002 and strategies for them were discussed. The subjects were male employees working in a steel company, 1, 135 (’99), 1, 077 (’00), 994 (’01) and 945 (’02). The positive ratios of occult urinary blood were 8.6% in ’99, 7.6% in ’00, 7.8% in ’01, 8.3% in ’02, respectively. Multiple logistic regression analysis showed that age and urinary protein were significant factors asociated positively with occult urinary blood. In general, a man who had urinary tract malignancy would have macroscopic hematuria in the course of the disease. Therefore, in people with recurrent occult urinary blood the risk of urinary malignancy is considered to be rare. The follow-up protocol was set up for employees with occult urinary blood. For four years 6 employees were referred to specialists (5 to a urologist and 1 to a nephrologist). No significant disease, including urinary tract malignancy, was detected.
    Download PDF (71K)
feedback
Top