巻号一覧
3 巻, 2 号
選択された号の論文の3件中1～3を表示しています
- |<
- <
- 1
- >
- >|
-
西田 正三1991 年 3 巻 2 号 p. 134-142
発行日: 1991/04/20
公開日: 2009/11/18
ジャーナル フリーPDF形式でダウンロード (1980K) -
第1報 曲げ強度に及ぼす混繊効果濱田 泰以, 前川 善一郎, 横山 敦士, 池川 直人, 松尾 達樹, 山根 正睦1991 年 3 巻 2 号 p. 157-164
発行日: 1991/04/20
公開日: 2009/11/18
ジャーナル フリーThermoplastic composites have great advantage over thermoset composites in productivity and properties. However, thermoplastic composites have not been used so widely. Several impregnation techniques have been specially developed for thermoplastic composites because of the difficulty in impregnation of their matrices.
In this paper, we propose a new impregnating system using a commingled yarn of continuous reinforcing fiber and thermoplastic matrix fiber, in order to facilitate the impregnation process. This yarn consists of glass fiber and Nylon 6 fiber. We are propose a quantitative method to evaluate the commingled state. We fabricated unidirectional composites using the commingled yarn. We performed bending tests and examined the influence of processing condition on the mechanical properties. Furthermore, unidirectional thermoplastic compositing using uncommingled yarn were also fabricated to evaluate the effect of the commingle process. It was clear that the commingled yarn composites hadl excelent impregnation under low pressure and short holding times, with excellent bending properties.抄録全体を表示PDF形式でダウンロード (2552K) -
和田 明紘, 川端 繁忠1991 年 3 巻 2 号 p. 165-170
発行日: 1991/04/20
公開日: 2009/11/18
ジャーナル フリーThe influence of mold temperature on the appearance of molded plastics was examined in injection molding of thermoplastic resins. When a mold cavity was filled with the inner surface temperature of the mold being kept higher than the glass transition temperature (Tg) of the resin, the injection molded article was found to have excellent good surface aesthetics, as follow;
•No Surface defects such as silver streaks, jetting and weld lines were observed in the injection molded articles.
•Uniform, high gloss moldings with little gradient in gloss, were obtained for rubber-modified resins such as HIPS and ABS.
•No fillers appeared on the surfaces of molded filled resins, for example, glassfilled ones. This implies that injection molding of filled resins results in the formation of skins without fillers.抄録全体を表示PDF形式でダウンロード (1879K)
- |<
- <
- 1
- >
- >|