成形加工
Online ISSN : 1883-7417
Print ISSN : 0915-4027
ISSN-L : 0915-4027
30 巻, 4 号
選択された号の論文の11件中1~11を表示しています
目次
巻頭言
解説:特集 ゴム物性の科学
技術報告
プリンキピア―常識を変えたモノたちの物語―
会議・見本市だより
論文
  • 富山 秀樹, 福澤 洋平, 福澤 大輔
    2018 年 30 巻 4 号 p. 162-169
    発行日: 2018/03/20
    公開日: 2020/08/25
    ジャーナル フリー

    Deep learning using an artificial intelligence algorithm was carried out in order to automatically determine the screw configuration of an intermeshing co-rotating twin screw extruder, and a system development was conducted to obtain an optimum output value for the specified extrusion conditions from the learning results. In deep learning, supervised learning was adopted that gives extrusion conditions and machinery configuration to the input layer and sets the analysis results and experiment results to the output layer. After performing the deep learning, judgment processing was carried out under the conditions of complete melting extrusion at just 200℃ as designation conditions, and four kinds of screw design were outputted. As a result of experiment verification of these four screws, it was confirmed that they satisfy the specified value with high accuracy. This suggested that it is possible to determine the screw configuration with deep experience and expertise by utilizing the artificial intelligence algorithm.

  • 冨岡 正雄, 石川 健, 井上 玲, 田中 達也
    2018 年 30 巻 4 号 p. 170-177
    発行日: 2018/03/20
    公開日: 2020/08/25
    ジャーナル フリー

    Hybridizations of materials or molding methods are effective tools as high-speed and low-cost molding technologies of CFRTP, and a hybrid injection molding system is one of them. This study investigated the influence of molding conditions in the hybrid injection molding on the interfacial adhesion between inserted material and injection-molded material by using temperature and pressure sensors in the mold. It was found that “temperature rise of the injection-resin”, “increase in the injection rate” and “pre-heating of the insert-material” are effective for improving the interfacial adhesion. Regarding the improvement of the interfacial adhesion due to “temperature rise of the injection-resin” and “increase in the injection rate”, the rise in the interface temperature during adhesion had a dominant influence on the adhesion. On the other hand, the pressure did not contribute to the interfacial adhesion. Moreover, it was assumed that “pre-heating of the insert-material” improves the adhesion with anchor effect due to roughening of the insert-material surface by heating.

feedback
Top