Science and Technology of Energetic Materials
Online ISSN : 2434-6322
Print ISSN : 1347-9466
ISSN-L : 0368-5977
84 巻, 6 号
選択された号の論文の2件中1~2を表示しています
  • Tomotaka Homae, Yuta Sugiyama, Takahiro Tamba, Tomoharu Matsumura, Kun ...
    2023 年84 巻6 号 p. 81-86
    発行日: 2023年
    公開日: 2024/01/11
    ジャーナル フリー
    In this study, the blast-mitigation effects of periodic obstacles installed on the floor and the ceiling of a tube are examined, considering their potential application for underground/subsurface explosive storage. A straight square tube, measuring 330 mm in length, 30 mm in width, and 30 mm in height, was prepared. One end of the tube was closed, and a specially-designed small detonator, which contained 100 mg lead azide, was ignited near this closed end of the tube as the test explosive. Rectangle obstacles, fixed on a thin plate, were installed on the tube floor, and their number and height were varied. The obstacles were also installed on the ceiling and the floor of the tube to examine the mitigation dependence on the number of surfaces on which the obstacles were installed. The pressure histories were measured at seven points on the extended center line outside the tube. The scaled distances of these seven points from the tube exit were 4.3 m・kg-1/3 to 30.2 m・kg-1/3. Our findings show that the blast-wave mitigation by the obstacles does not apparently depend on the number of obstacles. On the contrary, the obstacles on the ceiling in addition to the floor mitigated the blast wave remarkably, compared to that only on the floor, although the sum of the heights of the obstacles was identical. The obstacles whose height was more than half of the inner height of the tube mitigated the blast wave, whereas those with a height less than half of the tube height did not show any obvious mitigation effect. The number of surfaces with obstacles was found to be a dominant parameter to blast mitigation.
  • Takumi Egashira, Shigeru Tanaka, Kouki Hasegawa, Akihisa Kubota, Kazuy ...
    2023 年84 巻6 号 p. 87-89
    発行日: 2023年
    公開日: 2024/01/11
    ジャーナル フリー
    Shock imprinting technology using a polymer stamper enables the precise creation of fine imprints on metal plate surfaces. Particularly, thin stampers have shown exceptional effectiveness in this technology. Polyethylene terephthalate (PET) possesses favorable processability, making it suitable for manufacturing thin stampers; however, it lacks excellent mechanical strength. This study experimentally investigated the feasibility of employing a PET stamper in shockimprinting technology. Controlled pressure conditions can create ridges on the surface of a thick Al plate, reaching depths comparable to the cavity depth of the stamper. These results conclusively establish the applicability of PET stampers in shock imprinting technology and affirm the potential of PET as a promising candidate for a mold material due to its ease of preparation and low environmental impact.
feedback
Top