ターボ機械
Online ISSN : 1880-2338
Print ISSN : 0385-8839
ISSN-L : 0385-8839
41 巻, 6 号
選択された号の論文の4件中1~4を表示しています
論文
  • 山口 健, 田中 和博
    原稿種別: 論文
    2013 年 41 巻 6 号 p. 355-360
    発行日: 2013年
    公開日: 2015/06/13
    ジャーナル フリー
    The objective of this research was to investigate the transient torque converter performance used in an automobile. A new technique in computational fluid dynamics was introduced, which includes the inertia of the turbine in a three dimensional simulation of the torque converter during a launch condition. The simulation results were compared to experimental data. Good agreement between test and simulation was seen across the range of data. In addition, the flow structure inside the torque converter was visualized and compared to the result from a steady-state calculation.
  • (第2報:微小脈動調整機構の検証)
    小西 義昭, 古川 明徳
    原稿種別: 論文
    2013 年 41 巻 6 号 p. 361-367
    発行日: 2013年
    公開日: 2015/06/13
    ジャーナル フリー
    The reciprocating type pulsation-free pump generates whit pulsation by a change of the discharge pressure. The conventional measures were accompanied with the cams. Because the pulsation was caused by a decline of the pump volume efficiency due to the pressure and disagreement of the quantity of volume revision, the mechanism to adjust pulsation easily by establishing the pulsation corrective is proposed in the present paper and is confirmed by an examination.
  • (第3報:タービン諸特性(回転部重量、翼応力、動翼共振回避、Thomas Force) を考慮したロケットターボポンプタービンの多目的最適化)
    瀧田 純也, 福田 太郎, 宇山 遼一, 船﨑 健 一, 内海 政春
    原稿種別: 論文
    2013 年 41 巻 6 号 p. 368-377
    発行日: 2013年
    公開日: 2015/06/13
    ジャーナル フリー
    Because rocket turbopump turbine blades have higher loading, there is a possibility of shaft vibration problem due to “Thomas Force”. In order to reduce shaft vibrations, it is important to keep “Thomas Force”small, In the previous report, validity of optimization process for the reduction of Thomas Force was confirmed by performing Parameter Design and Multi-Objective Genetic Algorithm(MOGA). In this paper, by increasing the number of objective functions, the results of multi-objective optimization for reduction of Thomas Force and the considering the feasibility of blade structure are discussed. It was found that optimized blade reduced 10%in weight, 30%in Thomas Force, compared from the original blade.
  • 二見 昌寛, 鈴木 正己, 天久 和正
    原稿種別: 論文
    2013 年 41 巻 6 号 p. 378-383
    発行日: 2013年
    公開日: 2015/06/13
    ジャーナル フリー
    On a design and analysis method of wind turbine generators, Blade Element Mo-mentum(BEM)theory has been often used even now. BEM theory only requires a small computa-tional load. However, the measurement facilities such as wind tunnel experiments with two-dimensional airfoils are necessary because BEM theory uses two-dimensional airfoil performance. To find the two-dimensional airfoil performance at relatively low cost, calculation using Compu-tational Fluid Dynamics(CFD)is performed. In recent years, CFD analysis associated with de-velopment of computers becomes high speed and high performance. In this study, an analysis method of wind turbine performance using the conventional BEM theory and two-dimensional CFD is described and compared with experimental results. As a result, it was shown that the analysis method predicts the wind turbine performance with the practical accuracy.
feedback
Top