The possibility of attenuation of microseismic waves due to the presence of an upward folding of the ocean bottom into the liquid is discussed in this paper. The upward folding of the ocean bottom has been idealized by means of an irregularity in the form of a rectangle intruding into the liquid and the evaluation of the displacement component at any point of the solid medium has been carried out in two stages. First, the change in the incident mode of the surface wave due to the presence of the rectangular irregularity has been determined, and second, the subsequent change of the resulting displacement components due to the termination of the liquid layer and the step change in elevation of the solid medium at the continental margin has been discovered. Finally, numerical calculation has been made to determine the attenuation of the microseismic waves of different periods due to the presence of the rectangular irregularity at the ocean bottom.

抄録全体を表示

One method currently being considered for the disposal of high level radio-active waste is burial in the seabed. When a hot object is buried in soil, the temperature of the soil adjacent to the object is raised and there is transient heat flow away from the object. The rise in the temperature of the soil causes excess pore pressures to be generated and transient pore water diffusion also takes place. A finite element formulation of the coupled heat flow and consolidation problem is presented. The computer implementation of this formulation is found to compare favourably with analytical solutions based on the same physical principles.

抄録全体を表示

The effect of composition and controlled thermomechanical process parameters on the mechanical properties of HSLA steels is modelled using the Widrow-Hoff's concept of training a neural net with feed-forward topology by applying Rumelhart's back propagation type algorithm for supervised learning, using a Petri like net structure. The data used are from laboratory experiments as well as from the published literature. The results from the neural network are found to be consistent and in good agreement with the experimented results.

抄録全体を表示

Horizontal plate anchors are widely used in civil engineering constructions to resist vertical pulling loads. The available theoretical model suggested by Vesic to estimate the breakout resistance of plate anchors is in significant error, particularly for dense sandy soils. A theoretical model assuming a curved surface of failure through the surrounding soil, to evaluate the ultimate breakout resistance of horizontal plate anchors, has been proposed. It successfully brings out the concept of characteristics relative depth beyond which the breakout factor reaches a constant final value. It is capable of predicting breakout factors for wide range of values of angle of shearing resistance of sand.

抄録全体を表示

An unsupervised learning technique and an associative memory have been used for encoding weights by a special type of Petri network named Petri neural net for modelling the influence of alloying elements on the final property of the high strength low alloy steel. The combined effects of alloying elements for different strengthening mechanisms is predicted when weights and threshold values are chosen on the basis of metallurgical understanding. The technique is found to be effective to create an associative memory of input-output relations in unknown data sets so that the same can be subsequently be used as a predictive tool.

抄録全体を表示

Primarily from the point of view of improvement of yield strength due to additions of niobium, titanium and boron in HSLA steels, the experimental steels are divided into five classes. The data are then supplied for learning a Self Organising Map (Kohonen network). It is found that the network with six neurons possesses better capacity of prediction with unknown data. Another effort of clustering the steels according to its major strength contributing mechanisms is also made. But the capacity of the network to cluster unknown data is found to be rather poor and has failed to follow from the metallurgical principles. To avoid this limitation, Learning Vector Quantisation method is adopted to impart a certain amount of supervision in the learning process and it is found that the training pattern of the network attains a good convergence thereby leading to a good predictive ability.

抄録全体を表示

A boron treated copper bearing HSLA steel containing austenite formers like manganese and nickel, somewhat lower in amount than that in HSLA 100 variety of steel is chosen for the study. The role of thermomechanical processing on the microstructure and mechanical properties of the above steel has been investigated. Differential scanning calorimetric study is carried out for understanding the precipitation behaviour of copper in HSLA steel under the influence of boron. The microstructure of the experimental steel is found to consist of laths of martensites and bainite. MA constituents of ribbon like morphology are observed at the lath boundaries. Higher strength properties of the steel are attributed to the presence of finely distributed precipitates of copper and microalloy carbides.

抄録全体を表示

Simultaneous measurements of the total geomagnetic field intensity by the same type of the proton precession magnetometers at two stations in NW Turkey have been taken cooperatively by a research group since December 1970. Up to the end of July 1971 mainly three probable local magnetic changes were observed. It was seen that after a decrease in the local field at a magnetic station (Erdek) a few earthquakes occured at either nearly N or S of that station, and after an increase in the local field an earthquake took place nearly W of the same station. In this paper the data and some results of the first part of observations are given.

抄録全体を表示

Nine isoquinoline alkaloids belonging to the protoberberine, proaporphine and bisbenzyl-isoquinoline series were isolated from Caryomene olivascens (Menispermaceae). Four compounds are new : (-)-2-norlimacine (), (-)-caryolivine (), (+)-1, 2-dehydro-2-norlimacusine () and N-formylstepharine (). The last one is the first N-formyl derivative to be reported in the proaporphine group. Its biogenetic origin is discussed. Structures were established on the basis of 360 MHz (FT) nuclear magnetic resonance measurements and also by chemical correlation in the case of .

抄録全体を表示

Two new partially saturated tricyclic ring systems, , a, , , , 10, 10a, 11-octahydro-11-oxodibenz [, ] oxepins (a and ), and -thiepins (a and ) were synthesized. Compounds a and were desulfurized to give a pair of isomeric 2-methylbenzoylcyclohexanes (10a and 10). Deuterated a and (11a and 11) were prepared starting from butadiene- (12). The stereochemical features of a (trans), (cis), a (trans) and (cis) are compared with those of 10a, 10, 11a and 11 on the basis of proton nuclear magnetic resonance data.

抄録全体を表示

Nアルキル,:,10-ペリレンテトラカルボン酸モノアンヒドリド=モノイミド[a～]と芳香族アミン(アニリン,p-トルイジン,p-アニシジン,,-キシリジン,-アミノナゾベンゼン,およびo-フェニレンジアミン)を縮合して非対称型,:,10-ペリレンビス(ジカルボキシミド)誘導体-N-アルキル-N'-アリール-,:,10-ペリレンビス(ジカルボキシミド)(〔a～〕,〔a～〕,〔a～〕,〔a～〕,〔a～〕,および〔10a～〕)を合成した. これらの各誘導体はすべて赤色系の色相を示し, 顔料試験の結果N-ブチル-N'-アリール-,:,10-ペリレンビス(ジカルボキシミド)(たとえば〔〕や〔〕)がとくにすぐれた耐光性を示した.

抄録全体を表示

The correction factor (η_ie) for the ultimate bearing capacity of a footing placed adjacent to a slope, taking into account the combined effect of horizontal and vertical seismic loads, represented by horizontal and vertical seismic coefficients, k_h and k_v, respectively, was derived using a modified Janbu's slice method. The influence of slope angles ‘α’ on the values of ‘η_ie’ are studied here. It was found that the values of η_ie can be expressed as an exponential function of ‘k_h/(1-k_v)’ and ‘α’, with a measurable interdependency between ‘α’ and ‘η_ie’. The influence of ‘α’ on the value of ‘η_ie’ increases as the input value of ‘k_h/(1-k_v)’ increases. Equations derived based on the analytical results are proposed to account for this effect. Based on the analyses of 11 near-fault seismographers obtained in the 1999 Chi-Chi earthquake in Taiwan, a ratio between the vertical and the horizontal seismic coefficients, λ, of between ±.25 is suggested for including the combined effect of vertical and horizontal seismic forces in evaluating the seismic bearing capacity of footings located in near-fault areas.

抄録全体を表示

At present, analytical or empirical formula for seismic bearing capacity of footings adjacent to slopes is not available. This study uses a pseudo-static-based approach in conjunction with rigorous Janbu's slice method to derive analytical values of seismic bearing capacity factors (N_γ) and correction factors for the effects of inertia of soil mass and load inclinations for a rigid footing adjacent to cohesionless slopes. It is shown that both the bearing capacity factors (N_γ) and the correction factors for the seismic bearing capacity of footings placed on level ground derived herein are comparable with those reported in the literature. Empirical equations regarding the effects of slope angles and load inclinations, expressed using generalized forms of those proposed in the literature, are also derived. It is also found that the empirical equations derived in the present study provide values of correction factors in good agreements with the analytical ones, indicating the validity of using these empirical equations for assessing the bearing capacity of rigid footings situated on the slope subjected to pseudo-static seismic loading.

抄録全体を表示

(,)-2,-エポキシ-,,11,11-テトラメチルシクロウンデカ-,-ジエン(2)をフムレン1((2,,)-,,11,11-テトラメチルシクロウンデカ-2,,-トリエン)より合成する既知の合成法は実際に牧率が低く合成的に問題がある.さらに,2の合成はその反応性や物性の研究のために簡単に高牧率で行われることが望まれる.今回,2の新たな合成法と簡便な精製法を見いだし,2を高牧率で1から合成することができたので報告する.1のジエポキシ化,続く再結晶により得られたジエポキシド()は二価のチタンにより還元されて,1(273%)と(25%)と少量のを含む2を主生成物(42.%)として与えた.1とは原料として再利用できる.2の精製は1と同様硝酸銀()錯体の結晶で行い,純粋な2は1から通算牧率32.%で得られた.2の既知方法による合成は段階の反応と数回のカラム分離及び10%含浸シリカゲルカラム分離を必要とし牧率が極端に低い.今回,新しい2の合成法は2段階の反応で1回のカラム分離と再結晶により高い通算牧率を示す.

抄録全体を表示