The possibility of attenuation of microseismic waves due to the presence of an upward folding of the ocean bottom into the liquid is discussed in this paper. The upward folding of the ocean bottom has been idealized by means of an irregularity in the form of a rectangle intruding into the liquid and the evaluation of the displacement component at any point of the solid medium has been carried out in two stages. First, the change in the incident mode of the surface wave due to the presence of the rectangular irregularity has been determined, and second, the subsequent change of the resulting displacement components due to the termination of the liquid layer and the step change in elevation of the solid medium at the continental margin has been discovered. Finally, numerical calculation has been made to determine the attenuation of the microseismic waves of different periods due to the presence of the rectangular irregularity at the ocean bottom.

抄録全体を表示

The effect of composition and controlled thermomechanical process parameters on the mechanical properties of HSLA steels is modelled using the Widrow-Hoff's concept of training a neural net with feed-forward topology by applying Rumelhart's back propagation type algorithm for supervised learning, using a Petri like net structure. The data used are from laboratory experiments as well as from the published literature. The results from the neural network are found to be consistent and in good agreement with the experimented results.

抄録全体を表示

Horizontal plate anchors are widely used in civil engineering constructions to resist vertical pulling loads. The available theoretical model suggested by Vesic to estimate the breakout resistance of plate anchors is in significant error, particularly for dense sandy soils. A theoretical model assuming a curved surface of failure through the surrounding soil, to evaluate the ultimate breakout resistance of horizontal plate anchors, has been proposed. It successfully brings out the concept of characteristics relative depth beyond which the breakout factor reaches a constant final value. It is capable of predicting breakout factors for wide range of values of angle of shearing resistance of sand.

抄録全体を表示

An unsupervised learning technique and an associative memory have been used for encoding weights by a special type of Petri network named Petri neural net for modelling the influence of alloying elements on the final property of the high strength low alloy steel. The combined effects of alloying elements for different strengthening mechanisms is predicted when weights and threshold values are chosen on the basis of metallurgical understanding. The technique is found to be effective to create an associative memory of input-output relations in unknown data sets so that the same can be subsequently be used as a predictive tool.

抄録全体を表示

Primarily from the point of view of improvement of yield strength due to additions of niobium, titanium and boron in HSLA steels, the experimental steels are divided into five classes. The data are then supplied for learning a Self Organising Map (Kohonen network). It is found that the network with six neurons possesses better capacity of prediction with unknown data. Another effort of clustering the steels according to its major strength contributing mechanisms is also made. But the capacity of the network to cluster unknown data is found to be rather poor and has failed to follow from the metallurgical principles. To avoid this limitation, Learning Vector Quantisation method is adopted to impart a certain amount of supervision in the learning process and it is found that the training pattern of the network attains a good convergence thereby leading to a good predictive ability.

抄録全体を表示

A boron treated copper bearing HSLA steel containing austenite formers like manganese and nickel, somewhat lower in amount than that in HSLA 100 variety of steel is chosen for the study. The role of thermomechanical processing on the microstructure and mechanical properties of the above steel has been investigated. Differential scanning calorimetric study is carried out for understanding the precipitation behaviour of copper in HSLA steel under the influence of boron. The microstructure of the experimental steel is found to consist of laths of martensites and bainite. MA constituents of ribbon like morphology are observed at the lath boundaries. Higher strength properties of the steel are attributed to the presence of finely distributed precipitates of copper and microalloy carbides.

抄録全体を表示

Nine isoquinoline alkaloids belonging to the protoberberine, proaporphine and bisbenzyl-isoquinoline series were isolated from Caryomene olivascens (Menispermaceae). Four compounds are new : (-)-2-norlimacine (), (-)-caryolivine (), (+)-1, 2-dehydro-2-norlimacusine () and N-formylstepharine (). The last one is the first N-formyl derivative to be reported in the proaporphine group. Its biogenetic origin is discussed. Structures were established on the basis of 360 MHz (FT) nuclear magnetic resonance measurements and also by chemical correlation in the case of .

抄録全体を表示

Simultaneous measurements of the total geomagnetic field intensity by the same type of the proton precession magnetometers at two stations in NW Turkey have been taken cooperatively by a research group since December 1970. Up to the end of July 1971 mainly three probable local magnetic changes were observed. It was seen that after a decrease in the local field at a magnetic station (Erdek) a few earthquakes occured at either nearly N or S of that station, and after an increase in the local field an earthquake took place nearly W of the same station. In this paper the data and some results of the first part of observations are given.

抄録全体を表示

-(2-Aminophenylthio)-, -dichloropyridazine (I) on treating with dil. Hydrochloric acid or acetic acid gave -chloro-H-benzo[]pyridazino[, -][1, ]thiazine (, -diazapheno-thiazine type) through rearrangement and cyclization. -Chloro-10H-benzo[]pyridazino-[, -][1, ]thiazine (1, 2-diazaphenothiazine type) was obtained by either heating of I at 150°or treating of I with conc. hydrochloric acid through direct cyclization. The mechanism of the aforesaid reactions was discussed using a molecular orbital method. Several 1, 2-and , -diazaphenothiazine derivatives were synthesized.

抄録全体を表示

The ability of Climacodon septentrionalis to immobilize and kill a mycophagous nematode (Aphelenchoides sp.) in vitro is described for the first time. Two isolates produced droplets (20–45 μm in diameter) that formed at the apices of tall, stalked, and branching secretory cells (700–1,500 μm tall). On 2% modified malt extract agar, nematodes became enveloped in the droplets, which restricted their ability to move and resulted in complete immobilization and death within several hours of contact. The rate of decomposition of the nematodes varied considerably, with most individuals persisting for weeks whereas others were degraded within several days and appeared to be colonized by dense hyphal growth. This study provides the first documentation of a non-agaricoid fungus producing secretory cells that are able to immobilize nematodes.

抄録全体を表示

飼育条件下におけるヨーロッパキダイDentex dentex仔稚魚の成長, 発育, 形態の変化を, 同一飼育群から連続的に採集した固定標本を用いて検討した。孵化仔魚は2kl容の飼育槽でワムシ, アルテミア孵化幼生, 仔稚魚用配合飼料を用いて, 濾過海水 (塩分34-35) の流水, 18L: Dの人工照明条件下で集約的に飼育された。飼育期間中の水温は16.から21.2℃で推移した。孵化仔魚の平均全長 (TL) は2.80±.13mmで, 日令-に摂餌を開始し, 日令 (.72±.21mmTL, 167°D) で全個体が卵黄吸収を終了した。また油球の吸収は日令11 (206°D) であった。仔魚から稚魚への移行は日令27-34 (524-673°D) , 全長.42-.00mmの個体の間で観察され, また初期発育段階における外部形態の変化に対応する成長屈曲点が相対成長に現れた。水温16.-21.2℃における飼育条件下でのヨーロッパキダイの初期発育段階の成長は, 次式で表すことができた。Y=-++.0000 (γ=.967, n=1070, Yは全長mm, Xは日令) 。

抄録全体を表示

It has been shown after mathematical and mechanical investigation that Limit Equilibrium Method (LEM) can be considered as a method to obtain the necessary condition of Slip Line Method (SLM), and that the solution can be obtained under the condition that F_s=1 and ∂F_s/∂θ=O, where F_s is the safety factor and θ is the inclination of the plane on which the safety factor is defined. Next, the generalized LEM (GLEM) is proposed, dealing with the following points : (1) Triangular or quadrangular blocks can be treated; (2) Safety factors are defined also on interblock planes; and () All types of plastic problems, slope stability, bearing capacity, and earth pressure are identically formulated. Two situations regarding treatment of the moment equilibrium condition are discussed. GLEM is applied to well-known problems. The results agree well with those obtained by theoretical methods. GLEM can be used to obtain the distribution of earth pressure or bearing capacity. GLEM, Iike ordinary LEM, is very effective for the practical problems, but GLEM is more theoretical and it can result in more accurate solutions.

抄録全体を表示

BCR-ABL1 International Scale（IS）測定はチロシンキナーゼ阻害剤で治療されている慢性骨髄性白血病（CML）患者の治療効果をモニターする上で重要な検査法である。稀ではあるが，BCR-ABL1 IS測定ができないCMLが存在することが知られている。本研究において，我々は，そのようなBCR-ABL1 IS測定のできないCML患者を経験し，分子生物学的な方法で，その原因を解明した。本例ではABL1遺伝子における切断点がa2エクソン内にあることが分かり，そのことがABL1のa2エクソンを欠いた

14a（a）キメラ遺伝子のmRNAのみの発現を誘導していた。a2エクソンは本邦における検査部でのIS測定において重要な要素であり，これが欠損することが測定不能の原因であった。このようなIS測定ができない稀なCML症例をさらに集積して，その分子構造を解明することが待たれる。

抄録全体を表示