(³H) Tobramycin was used as a probe to determine the relationship between the structure of aminoglycoside antibiotics and their ability to remove this drug from its higher affinity binding site on the ribosome. The dissacharide moieties (neamine, tobramine, gentamine) appeared to have a common binding site, whereas the kanosamine, garosamine and ribose moieties determined the specificity of this binding. Amikacin and butikacin behaved in an anomalous manner in spite of their close structural relationship to tobramycin.

抄録全体を表示

The activities of tobramycin derivatives acetylated and ethylated on the 6'-N, 2'-N and 3-N positions were examined. The MICs of these derivatives against tobramycin sensitive strains indicated that 2'-N-ethylated and 6'-N-ethylated derivatives have a fairly good activity, and confirmed that the 3-N position is the most important one for antibiotic activity since 3-N derivatives were less active. The MICs of these derivatives against tobramycin resistant strains, and their inactivation by tobramycin modifying enzymes were examined. These results showed that 2'-N or 6'-N ethylation protects the drug against inactivation by AAC(2') or AAC(6'), respectively, and 2'-N-ethyltobramycin and 6'-N-ethyltobramycin were active against strains containing these modifying enzymes. On the other hand, 3-N ethylation protects the drug against inactivation by AAC(3) but 3-N-ethyl tobramycin does not inhibit strains containing this enzyme.

抄録全体を表示

Circuit techniques to enhance the linearity of input-voltage-to-current (V/I) conversion and to increase the output impedance of a current source by compensating for the low intrinsic gain of a transistor were introduced to realize a high-frequency operational transconductance amplifier (OTA) for a low supply voltage using sub-100-nm CMOS processes. Applying these techniques, a MOS th-order Gm- linear-phase low-pass filter (LPF) was realized using a 65nm CMOS process. A simplified biquad LPF that can serve as a component of a th-order LPF was newly developed by replacing OTAs with resistors. As a result, the -3dB frequency bandwidth, group delay ripple, 3rd-order distortion, and 3rd-order input intercept point (IIP3) were 200MHz, 2.2%, ≤ -55dB with a 100MHz input, and +10.3dBm, respectively, all with a ±0.1Vp-p input signal at each input terminal in the pseudodifferential configuration. The LPF including an output buffer dissipated 60mW in the case of a 1.2V supply. Wide spurious-free dynamic range (SFDR) characteristics were confirmed up to high frequencies.

抄録全体を表示

Stress wave theory is applied to open-ended pipe piles to clarify the effects of soil plug on the behaviour of piles during driving and static loading. Measured field data and various numerical models are reviewed ; methods are presented to calculate wave propagation in both the pile and the soil plug ; modelling is presented which takes into account the interaction between the soil plug and the pile ; also presented is simplified method to estimate the loadsettlement relation of the pipe pile in static loading. By correlating observed and calculated values in two analytical cases, the authors demonstrate that incorporation of the soil plug (modelled as a series of masses and springs) is required to correctly predict pile behaviour during driving and static loading.

抄録全体を表示

Repetitive liquefactions in angular and subangular gravels from an alluvial fan, in the case of two earthquakes with accelerations lower than that of a former which had caused liquefaction some months before, are described. The liquefaction took place from the surface, down to a depth of approximately 10 m. Water laden with sediments spouted out for some tens of minutes after the strong motion ceased. Knowledge of the grain size distribution of the sediments inside the body of the alluvial fan roughly defines the areas of the fan prone to future liquefaction. Non-repetitive liquefaction in overconsolidated fine fluvio-lacustrine sand of glacial origin at the unusual depth of 14 m to 16 m is also described. From the observation of sand lifted up for 10 m inside a large diameter well, and of that which spouted out from several microvents, it was estimated that extra-pore pressure was close to lithostatic conditions. Nevertheless, modeling of intrinsic pore pressure buildup on the DESRA2 programme gives lower values than the experimental one. Geotechnical characteristics of the 12 m-thick sandy stratum indicate that the upper part is unusually soft, either due to water circulation or past repetitive liquefactions which prevented reconsolidation. It is suggested that excess pore pressure generated by the earthquake was also due to redistribution of pressure from adjacent sediments.

抄録全体を表示

A high performance liquid chromatographic method for the simultaneous determination of the cyanogenic glycosides, i. ., amygdalin (AM) and prunasin (PR), and their degradation products, i. ., benzaldehyde (BAL) and benzoic acid (), in processed foods containing ume (Japanese apricot Prunus mume Sieb et Zucc.) was developed.
The sample was extracted with 0.05M citric acid solution and cleaned up by use of a Seppak cartridge. The extract was chromatographed on a Capcell Pak SG120 column with acetonitrile-water-0.2M phosphate buffer, pH .0 (16: 79: 5). Detection was achieved with a UV monitor set at 210nm. The peaks corresponding to AM and PR were confirmed by examination of the effect of emulsin treatment.
The recoveries from ume extract, umeboshi (dried and salted ume), umeshu (Japanese apricot wine) and ume jam fortified with AM, PR, BAL and at levels of 40-100μg/g each were 86.-100.6% (. V. 3.-.%) for AM, 69.-105.3% (0.-.2%) for PR, 71.-85.0% (1.-2.6%) for BAL and 82.-99.1% (0.-.%) for , except for AM in the ume extract and the umeboshi. AM in ume extract and umeboshi could not be determined owing to interference by contaminants.
The determination limits were 10μg/g for AM, 2μg/g for PR, and 1μg/g for BAL and , respectively.

抄録全体を表示

The mechanism of wave-induced instability in a permeable seabed have been studied for more than two decades. The distinction between shear failure and liquefaction, however, has not been clearly defined. This paper presents a fundamental study on the differences in two failure modes for a fully saturated seabed of both finite and infinite thickness. The wave-induced effective stresses and pore pressure, obtained from an analytical solution of Biot's pore-elastic consolidation theory, were employed to examine the failure modes under a two-dimensional plane strain condition. A case study is presented to examine the failure modes with respect to several parameters, such as excess pore pressure, seepage flow, seepage force, failure areas and stress path in the seabed. The conclusions obtained from this study were as follows ; (1) the thickness of a permeable seabed affects the pore pressure and effective stress response to ocean waves and the failure mode of the seabed, (2) either a liquefaction or shear failure, or both, occur in the seabed, even in the saturated seabed, (3) the Mohr-Coulomb's failure criterion, when combined with elastic stresses, can not be employed to estimate the liquefaction failure in the seabed, () the liquefaction can be evaluated by a criterion in terms of the excess pore pressure, (5) The liquefied zone in the seabed is significantly different from the shear failure zone. The shape beneath the seabed surface for the former is almost identical to the contour where the upward seepage flow is concentrated.

抄録全体を表示

Field data indicate that the P-wave velocity in sand or gravel is sometimes much lower than that of water, even if the soil is below the water table. It is well understood that a slight decrease in saturation normally evaluated by the B-value has a significant effect on undrained shear behavior like liquefaction of saturated soil. In the first part of this research, theoretical formulations of the B-value, P-wave velocity and Poisson's ratio are made by taking into account the decrease in bulk modulus of water due to a mixture of air bubbles. Then, computations are carried out using formulas based on the soil properties of a typical sand or gravelly soils and Masa soil from the Kobe area to make charts correlating the variables. These charts indicate that a small decrement in the B-value in the interval of B=1.0 to 0. will considerably decrease the P-wave velocity. Thus, the P-wave velocity which is easily measured in the field can serve as a convenient index to quantitatively evaluate the insitu soil B-value.

抄録全体を表示

A sample of [³H] tobrarnycin (5, 000 Ci/Mole) has been synthetized and incubated with
the bacterial ribosome and its subunits. The results obtained show that this antibiotic has
two types of binding sites. The primary one is probably responsible for the inhibition of
protein synthesis whereas the secondary one is probably related to the misreading and reading
tiirough of the messenger RNA.

抄録全体を表示

The syntheses of (S)-13-hydroxy-(2, , )-tetradecatrienoic acid (1) and (2, , Z-tetradecatrienoic acid (2) were carried out by using the Wittig reaction as the key step. The asymmetric center at -13 and the double bond between - and - for natural compound 1 were reconfirmed as being of (S) configuration and , respectively. The relationship between the structure of the unsaturated hydroxy fatty acids and their inhibitory effect on the growth of lettuce was investigated.

抄録全体を表示

In the 1993 Kushiro-oki Earthquake of Richter magnitude ., simultaneous recording of earthquake motions was successfully made at the ground surface and at a depth of 77 meters in a dense saturated sand deposit. The peak horizontal acceleration was 0.47 g on the ground surface and 0.21 g at a depth of 77 meters. The acceleration record at the ground surface showed a distinctive ground response, which consisted of a cyclic motion having a period of about 1.5 seconds overlain by a spike at each peak of the motion. In order to study the mechanism of this peculiar ground response, effective stress analysis was conducted on the dense saturated sand deposit. The model used for this study was a strain space multiple mechanism model, which takes into account the effect of principal stress axis rotation. The recorded earthquake motion at a depth of 77 meters was used as the input earthquake motion for the analysis. Sampling after in-situ freezing was done in order to evaluate the properties of the sand. The results of the analysis indicated that the observed ground response was due to the effect of dilatancy of sand, which plays a significant role in the response of the dense saturated sand deposits during strong earthquake motions.

抄録全体を表示

In the seismic analysis of pile foundations the soil is often assumed to be an elastic material and the pressure at the soil pile interface is not limited during the analysis. This may result in a considerable error, as the computed pressure from an elastic analysis may go well beyond the ultimate lateral pressure of real soil. In fact, significant yielding at the soil-pile interface has been observed during real earthquakes, and also in laboratory tests. The yield zone is usually near the ground surface where the effect of inertial force due to the superstructure is higher. This yielding redefines the pile response, and in general cannot be ignored. In order to examine the effects of soil yielding on the internal pile response during earthquakes an approximate analysis is described in this paper which is an extension of a static method developed by the second author (1982) for the analysis of piles subjected to lateral soil movement. This method is then used to investigate the effects of soil yielding on the internal response of piles through a comparative study in which real earthquakes are used. It is shown that for strong earthquakes and heavily loaded piles the soil yielding may considerably increase the amount of maximum pile moment developed in the pile. A marked difference in the effects of yielding on the pile moment and shear is observed and discussed.

抄録全体を表示

The interaction between a penetrating shaft and the surrounding soil media under impact loading is a frequently encountered phenomenon in geotechnical engineering. Examples of such dynamic soil/shaft interaction would include dynamic pile driving, standard penetration testing (SPT), and dynamic driven rod test. Presented in this paper is a novel approach, based on the principle of dynamic system identification, which enables identification of dynamic soil-pile interaction model parameters. The analytical transfer function, relating the output stress wave forms to the input stress wave forms in the soil/shaft system, is derived using the Laplace and Fourier Transform techniques and the one-dimensional wave propagation theories. A numerical solution algorithm based on a variation of gradient method is coded into a micro-computer based program to solve the frequency-dependent soil-pile interaction parameters (Smith model) : soil damping and soil spring stiffness. To further reduce the amount of computational effort required in the solution of the frequency-dependent dynamic soil properties, it is suggested that the solution be obtained for the first-mode natural frequency of the measured stress waves. The results obtained from this simplified solution algorithm, when compared with both numerical simulations and controlled laboratory tests, are reasonably acceptable. The proposed parameter identification technique offers a viable alternative data interpretation procedure for deducing pertinent Smith model parameters used frequently in pile driving analysis.

抄録全体を表示

In this paper, centrifuge shaking table tests were conducted in order to understand the performance of seawalls during a seismic event. The model tests showed that the displacement of the caisson was much affected by the seaward shear deformation of the sand seabed beneath it during shaking. It was also confirmed that an armored embankment played an important role in the displacement of the caisson during shaking. Based on these test results, a two-dimensional DEM-FEM coupled analysis method was newly developed to numerically predict the deformation of seawalls covered with armored embankments during earthquakes. The movements of the armor units were calculated by DE analysis and deformations of the caisson, rubble mound, sand seabed and backfill were calculated by FE analysis considering the non-linearity of the soil materials based on the effective stress. Dynamic interaction was taken into account by delivering the nodal displacements of the finite elements or the nodal forces converted from the contact forces through the imaginary distinct elements defined at the boundaries between the DE and FE domain. The applicability of this method to the prediction of the deformation of seawalls was verified through numerical simulations of the centrifuge model test.

抄録全体を表示

Seismic records obtained from a seismometer array located in downtown Tokyo Japan for about ten years were inversely analyzed to estimate the dynamic soil parameters. Due to the illposed nature of the problem, the simple and often used "least square method" does not properly estimate the parameters. The Extended Bayesian Method combined with the Akaike Bayesian Information Criterion was introduced to overcome this difficulty. The results obtained were compared with dynamic triaxial test results obtained at the time of the seismometer installation. The shear moduli agree quite well with the estimated results, however the damping ratios estimated are slightly higher than the ones obtained in the laboratory.

抄録全体を表示