The possibility of attenuation of microseismic waves due to the presence of an upward folding of the ocean bottom into the liquid is discussed in this paper. The upward folding of the ocean bottom has been idealized by means of an irregularity in the form of a rectangle intruding into the liquid and the evaluation of the displacement component at any point of the solid medium has been carried out in two stages. First, the change in the incident mode of the surface wave due to the presence of the rectangular irregularity has been determined, and second, the subsequent change of the resulting displacement components due to the termination of the liquid layer and the step change in elevation of the solid medium at the continental margin has been discovered. Finally, numerical calculation has been made to determine the attenuation of the microseismic waves of different periods due to the presence of the rectangular irregularity at the ocean bottom.

抄録全体を表示

This study aimed to determine the prevalence of fecal carriage of extended spectrum β-lactamase (ESBL) and/or plasmidic AmpC β-lactamase (pAmpC) producing Escherichia coli among dogs (n=428) in Turkey. Polymerase chain reaction (PCR) and sequencing were used to characterize genes encoding β-lactamase and plasmid mediated quinolone resistance (PMQR). Antimicrobial susceptibility testing and PCRs for virulence genes and phylogenetic groups were also performed. Cefotaxime resistant

. coli isolates were detected in 95 (.2%) of the swab samples. Sequencing analysis results showed occurrence of various β-lactamase genes: bla_CTX-M-15 (62), blaTEM-

1b

(42), bla_CMY-2 (

22

), blaCTX-M-

3

(16), bla_CTX-M-1 (15), bla_OXA-1 (

9

) and bla_SHV-12 (

3

) alone or in combination. The most frequently encountered phylogenetic group was group A₁ (35.

8

%), followed by group D₂ (

22

.1%),

B

1 (15.

8

%), D₁ (

9

.

5

%),

A₀

(7.4%),

B2₂

(

5

.

3

%) and

B2₃

(4.2%), respectively. PMQR genes, aac(6’)-Ib-cr, qnrS1 and qnrB10 were detected in 25.

3

, 10.

5

and 1.1% of the isolates, respectively. While all isolates were susceptible to imipenem and amikacin, resistance rates to non-β-lactam antibiotics ranged from 20.

0

% for tobramycin to 56.

8

% for tetracycline. The virulence genes were only detected in 34 (36.2%) of the isolates and this isolates carried single or various combination of virulence genes of iucD, papC, papE,

f17a

-A and eaeA. Four isolates were identified as human virulent pandemic CTX-M-15 producing

E

. coli clone O25

b

:ST131/

B

2. To the best of our knowledge, this is the first study to show fecal carriage of ESBL/pAmpC type β-lactamase producing

E

. coli isolates among dogs in Turkey.

抄録全体を表示

The ability of Climacodon septentrionalis to immobilize and kill a mycophagous nematode (Aphelenchoides sp.) in vitro is described for the first time. Two isolates produced droplets (20–45 μm in diameter) that formed at the apices of tall, stalked, and branching secretory cells (700–1,500 μm tall). On 2% modified malt extract agar, nematodes became enveloped in the droplets, which restricted their ability to move and resulted in complete immobilization and death within several hours of contact. The rate of decomposition of the nematodes varied considerably, with most individuals persisting for weeks whereas others were degraded within several days and appeared to be colonized by dense hyphal growth. This study provides the first documentation of a non-agaricoid fungus producing secretory cells that are able to immobilize nematodes.

抄録全体を表示

The phase diagrams of the Ni-Mo- and Ni-W- ternary systems in the region of less than 50mol% were constructed by thermodynamic calculation, based on the data obtained by thermodynamic measurement of the related materials. We found three ternary eutectic points and three or two ternary peritecto-eutectic points as follows:
:L (1365K, 71.mol%Ni-6.mol%Mo-.mol%)=(Ni)++
:L (1355K, 62.mol%Ni-2.mol%Mo-30.mol%)=++
:L (1445K, 42.mol%Ni-30.6mol%Mo-10.mol%)=(Ni)+NiMo+
P₁:L (1812K, 34.mol%Ni-42.mol%Mo-.mol%)+MoB=+
P₂:L (1633K, 42.mol%Ni-40.4mol%Mo-17.mol%)+Mo=+
:L (1812K, 53.mol%Ni-33.7mol%Mo-12.mol%)+Mo=NiMo+
:L (1622K, 51.mol%Ni-31.6mol%W-17.4mol%)=(Ni)+W+
:L (1260K, 71.mol%Ni-7.mol%W-.mol%)=(Ni)++
:L (1291K, 65.4mol%Ni-4.mol%W-29.mol%)=++
P₁:L (2115K, 23.mol%Ni-43.1mol%W-33.1mol%)+WB=+
P₂:L (1657K, 48.mol%Ni-33.1mol%W-18.mol%)+=W+
The calculated phase diagrams are expected to be useful for the development of new Ni-based heat-, corrosion- or wear-resistance alloys.

抄録全体を表示

A sample of [

3H

] tobrarnycin (

5

, 000 Ci/Mole) has been synthetized and incubated with
the bacterial ribosome and its subunits. The results obtained show that this antibiotic has
two types of binding sites. The primary one is probably responsible for the inhibition of
protein synthesis whereas the secondary one is probably related to the misreading and reading
tiirough of the messenger RNA.

抄録全体を表示

A comparative study of the static and dynamic response of a slope is carried out, using the large deformation theory of the updated Lagrangian formulation and the conventional infinitesimal theory. In the static analysis, a strength reduction method proposed by one of the authors is used to evaluate the safety factor of the slope. It is found that by the large deformation theory, the safety factor is larger than that calculated by the infinitesimal theory, and this difference becomes large along with the reduction of elastic modulus. In the dynamic analysis, it is observed that the large deformation theory gives smaller sliding displacement and larger response acceleration than the infinitesimal approach. It is concluded that in many cases the large deformation approach gives more adequate solutions.

抄録全体を表示

Six new cembranoids sarcophytol P (), R (4), S (), K (), (11), and T (13) were isolated from the soft coral Sarcophyton glaucum. Sarcophytol P () was shown to be the 20-hydroxy derivative of the major component sarcophytol A (1), and afforded the cyclization product 6 in CHCl_ at room temperature, in a same way as in 1. Sarcophytols R (4) and S () were correlated to 1, by conversion of its 7R,R and 7S,S epoxide derivatives. Sarcophytol K() was a 13, 14-dihydroxycembranoid having a 1,Z-diene moiety. The absolute configuration of and its 1Z,- and 1Z,Z-isomers sarcophytol (2) and J (10) were determined by circular dichroism study of their bis-p-dimethylaminobenzoate derivatives. Sarcophytols (11) and T (13) were 1- and 1,Z-isomers of 1. Compound 11 showed characteristic broadening of the ^1H-NMR chemical shifts, due to the restricted conformational interconversion. Using the three cembranoids sarcophytols (11, 1,), N (15, 1Z,Z) and T (13,1,Z), spontaneous autoxidation-cyclization, in CHCl_,was examined, in order to compare the stereochemical course of the reaction with that of 1 (1Z,), which affords trans-fused bicyclo[..]tetradecene systems. The 1,Z-isomer 13 gave the same cyclization product 18, as in the reaction of 1, even though it is isomeric at C-1,. The 1Z,Z isomer 15 gave 19, in consequence of the reversed geometry at C- of 15. The 1,-isomer (11) gave the bicyclic product , having an antipodal fusion as compared with 19. This was confirmed by PCC oxidation of 19 and , giving enantiomeric ketones 23 and 24 respectively. The 1(14)-epoxide 26 was shown to be the immediate precursor of , and acounted for the inversion of the geometry at C-1 of the cyclization product. Compound 26 is isomeric with the epoxide 17 derived from 1. The epoxide 17 is the postulated precursor in the conversion of 13 to 18. It is noteworthy that the mode of antipodal fusion of the cyclopentane rings, in 18 and , was controlled by the chirality of the epoxy rings. The C-14 hydroxyl group participates in the transannular cyclization, but was found not to be the requisite functional group for the reaction. Similar treatment of cembrene C (30), the parent hydrocarbon of 1, also reacted in CHCl_ giving the bicyclic product 32.

抄録全体を表示

The effect of composition and controlled thermomechanical process parameters on the mechanical properties of HSLA steels is modelled using the Widrow-Hoff's concept of training a neural net with feed-forward topology by applying Rumelhart's back propagation type algorithm for supervised learning, using a Petri like net structure. The data used are from laboratory experiments as well as from the published literature. The results from the neural network are found to be consistent and in good agreement with the experimented results.

抄録全体を表示

Horizontal plate anchors are widely used in civil engineering constructions to resist vertical pulling loads. The available theoretical model suggested by Vesic to estimate the breakout resistance of plate anchors is in significant error, particularly for dense sandy soils. A theoretical model assuming a curved surface of failure through the surrounding soil, to evaluate the ultimate breakout resistance of horizontal plate anchors, has been proposed. It successfully brings out the concept of characteristics relative depth beyond which the breakout factor reaches a constant final value. It is capable of predicting breakout factors for wide range of values of angle of shearing resistance of sand.

抄録全体を表示

An unsupervised learning technique and an associative memory have been used for encoding weights by a special type of Petri network named Petri neural net for modelling the influence of alloying elements on the final property of the high strength low alloy steel. The combined effects of alloying elements for different strengthening mechanisms is predicted when weights and threshold values are chosen on the basis of metallurgical understanding. The technique is found to be effective to create an associative memory of input-output relations in unknown data sets so that the same can be subsequently be used as a predictive tool.

抄録全体を表示

Primarily from the point of view of improvement of yield strength due to additions of niobium, titanium and boron in HSLA steels, the experimental steels are divided into five classes. The data are then supplied for learning a Self Organising Map (Kohonen network). It is found that the network with six neurons possesses better capacity of prediction with unknown data. Another effort of clustering the steels according to its major strength contributing mechanisms is also made. But the capacity of the network to cluster unknown data is found to be rather poor and has failed to follow from the metallurgical principles. To avoid this limitation, Learning Vector Quantisation method is adopted to impart a certain amount of supervision in the learning process and it is found that the training pattern of the network attains a good convergence thereby leading to a good predictive ability.

抄録全体を表示

A boron treated copper bearing HSLA steel containing austenite formers like manganese and nickel, somewhat lower in amount than that in HSLA 100 variety of steel is chosen for the study. The role of thermomechanical processing on the microstructure and mechanical properties of the above steel has been investigated. Differential scanning calorimetric study is carried out for understanding the precipitation behaviour of copper in HSLA steel under the influence of boron. The microstructure of the experimental steel is found to consist of laths of martensites and bainite. MA constituents of ribbon like morphology are observed at the lath boundaries. Higher strength properties of the steel are attributed to the presence of finely distributed precipitates of copper and microalloy carbides.

抄録全体を表示

The paper presents results from an extensive experimental model study of response of dry sand to impact of a rigid tamper. In the laboratory tests a circular steel tamper was repeatedly dropped on sand contained in a large tank. Measurements included tamper acceleration aud soil pressure at impact, tamper settlement, aud soil densities and strains. Effects of tamper drop height, weight and contact area were investigated. A method is presented for the evaluation of global dynamic stiffness of the soil mass affected by the impact by calculating a dynamic settlement modulus (DSM). The DSM values are determined from integration of the impact acceleration record with respect to time using measured integration constants. DSM values show good correlation to soil densities and corresponding elastic moduli obtained from laboratory tests for loose sand. However, for dense sand, results indicate apparent discrepancies between elastic modulus and the higher DSM values. Analyses of normalized impact energy and the resulting densification in the sand in terms of normalized dimensions of volumetric strain (relative density) contours show unique correlations which are used for a proposed rational design method for dynamic compaction in dry sandy soils.

抄録全体を表示