Two new polyacetylene compounds (, 6, 12)-1-acetoxy--isovaleryloxytetradeca-, 6, 12-trien-, 10-diyn-14-ol (B), and (, 6, 12)-1-acetoxy--(2-methylbutyryloxy)tetradeca-, 6, 12-trien-, 10-diyn-14-ol (C) have been isolated along with (, 6, 12)-1-acetoxy--senecioyloxytetradeca-, 6, 12-trien-, 10-diyn-14-ol (A) from Atractylodes Rhizome (Karabyakujutu). The structures of these compounds were determined on the basis of their spectral data.

抄録全体を表示

Static characteristics of two different structured InAlGaAs/InAlAs superlattice avalanche photodiodes (SLAPDs) cooled by liquid nitrogen were evaluated at a wavelength of 1. μm. The dark current of the SLAPD having a thick superlattice layer of 0.504 μm was ×10^-13 A. This was successively reduced by four orders of magnitude compared to that of the thin layer SLAPD of 0.231 μm at a breakdown voltage of around 20 V. The thickened layer was effective in suppressing tunneling dark current. An output current of 1.7×10^-12 A at a bias voltage of 15 V was measured for an optical input with a wavelength of 1. μm and a signal power of 1×10^-12 W. This showed a sharp distinction from the dark current.

抄録全体を表示

The syntheses of (S)-13-hydroxy-(2, , )-tetradecatrienoic acid (1) and (2, , Z-tetradecatrienoic acid (2) were carried out by using the Wittig reaction as the key step. The asymmetric center at C-13 and the double bond between C- and C- for natural compound 1 were reconfirmed as being of (S) configuration and , respectively. The relationship between the structure of the unsaturated hydroxy fatty acids and their inhibitory effect on the growth of lettuce was investigated.

抄録全体を表示

A comparative study of the static and dynamic response of a slope is carried out, using the large deformation theory of the updated Lagrangian formulation and the conventional infinitesimal theory. In the static analysis, a strength reduction method proposed by one of the authors is used to evaluate the safety factor of the slope. It is found that by the large deformation theory, the safety factor is larger than that calculated by the infinitesimal theory, and this difference becomes large along with the reduction of elastic modulus. In the dynamic analysis, it is observed that the large deformation theory gives smaller sliding displacement and larger response acceleration than the infinitesimal approach. It is concluded that in many cases the large deformation approach gives more adequate solutions.

抄録全体を表示

In the seismic analysis of pile foundations the soil is often assumed to be an elastic material and the pressure at the soil pile interface is not limited during the analysis. This may result in a considerable error, as the computed pressure from an elastic analysis may go well beyond the ultimate lateral pressure of real soil. In fact, significant yielding at the soil-pile interface has been observed during real earthquakes, and also in laboratory tests. The yield zone is usually near the ground surface where the effect of inertial force due to the superstructure is higher. This yielding redefines the pile response, and in general cannot be ignored. In order to examine the effects of soil yielding on the internal pile response during earthquakes an approximate analysis is described in this paper which is an extension of a static method developed by the second author (1982) for the analysis of piles subjected to lateral soil movement. This method is then used to investigate the effects of soil yielding on the internal response of piles through a comparative study in which real earthquakes are used. It is shown that for strong earthquakes and heavily loaded piles the soil yielding may considerably increase the amount of maximum pile moment developed in the pile. A marked difference in the effects of yielding on the pile moment and shear is observed and discussed.

抄録全体を表示

The interaction between a penetrating shaft and the surrounding soil media under impact loading is a frequently encountered phenomenon in geotechnical engineering. Examples of such dynamic soil/shaft interaction would include dynamic pile driving, standard penetration testing (SPT), and dynamic driven rod test. Presented in this paper is a novel approach, based on the principle of dynamic system identification, which enables identification of dynamic soil-pile interaction model parameters. The analytical transfer function, relating the output stress wave forms to the input stress wave forms in the soil/shaft system, is derived using the Laplace and Fourier Transform techniques and the one-dimensional wave propagation theories. A numerical solution algorithm based on a variation of gradient method is coded into a micro-computer based program to solve the frequency-dependent soil-pile interaction parameters (Smith model) : soil damping and soil spring stiffness. To further reduce the amount of computational effort required in the solution of the frequency-dependent dynamic soil properties, it is suggested that the solution be obtained for the first-mode natural frequency of the measured stress waves. The results obtained from this simplified solution algorithm, when compared with both numerical simulations and controlled laboratory tests, are reasonably acceptable. The proposed parameter identification technique offers a viable alternative data interpretation procedure for deducing pertinent Smith model parameters used frequently in pile driving analysis.

抄録全体を表示

A biosynthetic pathway for (

)-methyl cinnamate formation was evaluated in Tricholoma matsutake by tracer experiments using ¹³C- and ²H-labeled precursors. One hundred percent selective ¹³C incorporation was observed when L-[1,2,,,,6,7,,-

13C₉

, ^15/N]phenylalanine was converted to (

E

)-[1,2,

3

,

4

,

5

,6,7,

8

,

9

-

13C₉

]cinnamate and (

E

)-[1,2,

3

,

4

,

5

,6,7,

8

,

9

-

13C₉

]methyl cinnamate. Similarly, 100% selective ¹³C incorporation was observed when (

E

)-[1,2,

3

,

4

,

5

,6,7,

8

,

9

-

13C₉

]cinnamate was converted to (

E

)-[1,2,

3

,

4

,

5

,6,7,

8

,

9

-

13C₉

]methyl cinnamate. In contrast, the ²H incorporation selectivities were

82

.1% and

81

.

4

% when L-[2,

3

,

4

,

5

,6,7,7,

8

-

2H₈

]phenylalanine was converted to (

E

)-[2,

3

,

4

,

5

,6,7,

8

-²H₇]cinnamate and (

E

)-[2,

3

,

4

,

5

,6,7,

8

-²H₇]methyl cinnamate, respectively. Thus, T. matsutake synthesizes (

E

)-methyl cinnamate from L-phenylalanine via (

E

)-cinnamate. (

E

)-cinnamate was likely formed through two pathways: one was major and the other was a minor.

抄録全体を表示

The performance of single pitch and multi pitch screw anchors during the application of installation torque is presented. An experimental testing program was conducted using five models of screw anchors with different geometry. The effect of the shape of the screw element, sand properties, and installation depth on the required installation torque value was examined. A theoretical model was developed from which the required installation torque value can be calculated in terms of the influencing factors. The required installation torque can be determined in terms of the ultimate uplift resistance calculated from any of the available theories. Based on the actual installation torque value measured in the field, the anticipated pullout capacity can be back calculated from the present theory. A comparison between theoretical and experimental results showed good agreement. Also, good agreement was observed when the present theoretical results were compared with the available field results reported in the literature.

抄録全体を表示

The correction factor (η_ie) for the ultimate bearing capacity of a footing placed adjacent to a slope, taking into account the combined effect of horizontal and vertical seismic loads, represented by horizontal and vertical seismic coefficients, k_h and k_v, respectively, was derived using a modified Janbu's slice method. The influence of slope angles ‘α’ on the values of ‘η_ie’ are studied here. It was found that the values of η_ie can be expressed as an exponential function of ‘k_h/(1-k_v)’ and ‘α’, with a measurable interdependency between ‘α’ and ‘η_ie’. The influence of ‘α’ on the value of ‘η_ie’ increases as the input value of ‘k_h/(1-k_v)’ increases. Equations derived based on the analytical results are proposed to account for this effect. Based on the analyses of 11 near-fault seismographers obtained in the 1999 Chi-Chi earthquake in Taiwan, a ratio between the vertical and the horizontal seismic coefficients, λ, of between ±0.25 is suggested for including the combined effect of vertical and horizontal seismic forces in evaluating the seismic bearing capacity of footings located in near-fault areas.

抄録全体を表示

At present, analytical or empirical formula for seismic bearing capacity of footings adjacent to slopes is not available. This study uses a pseudo-static-based approach in conjunction with rigorous Janbu's slice method to derive analytical values of seismic bearing capacity factors (N_γ) and correction factors for the effects of inertia of soil mass and load inclinations for a rigid footing adjacent to cohesionless slopes. It is shown that both the bearing capacity factors (N_γ) and the correction factors for the seismic bearing capacity of footings placed on level ground derived herein are comparable with those reported in the literature. Empirical equations regarding the effects of slope angles and load inclinations, expressed using generalized forms of those proposed in the literature, are also derived. It is also found that the empirical equations derived in the present study provide values of correction factors in good agreements with the analytical ones, indicating the validity of using these empirical equations for assessing the bearing capacity of rigid footings situated on the slope subjected to pseudo-static seismic loading.

抄録全体を表示

This paper is concerned with dynamics of the standard penetration test (SPT). The usefulness of mounting strain gages at two different stations along a driven rod is described, together with a workable procedure of analysis. The analysis procedure makes use of the traveling time between the two gage points and enables one to identify the particle velocity, the displacement and the stress at any station of the rod, as well as the energy actually transmitted from a hammer to the rod. Particular attention is called for the consequence of inevitable, small errors in strain data upon such identifications. A pertinent procedure of error-correction is proposed and its validity is substantiated against the performance of well instrumented SPTs performed by the authors.

抄録全体を表示

The activities of tobramycin derivatives acetylated and ethylated on the 6'-N, 2'-N and -N positions were examined. The MICs of these derivatives against tobramycin sensitive strains indicated that 2'-N-ethylated and 6'-N-ethylated derivatives have a fairly good activity, and confirmed that the -N position is the most important one for antibiotic activity since -N derivatives were less active. The MICs of these derivatives against tobramycin resistant strains, and their inactivation by tobramycin modifying enzymes were examined. These results showed that 2'-N or 6'-N ethylation protects the drug against inactivation by AAC(2') or AAC(6'), respectively, and 2'-N-ethyltobramycin and 6'-N-ethyltobramycin were active against strains containing these modifying enzymes. On the other hand, -N ethylation protects the drug against inactivation by AAC() but -N-ethyl tobramycin does not inhibit strains containing this enzyme.

抄録全体を表示

(

3H

) Tobramycin was used as a probe to determine the relationship between the structure of aminoglycoside antibiotics and their ability to remove this drug from its higher affinity binding site on the ribosome. The dissacharide moieties (neamine, tobramine, gentamine) appeared to have a common binding site, whereas the kanosamine, garosamine and ribose moieties determined the specificity of this binding. Amikacin and butikacin behaved in an anomalous manner in spite of their close structural relationship to tobramycin.

抄録全体を表示

Circuit techniques to enhance the linearity of input-voltage-to-current (V/I) conversion and to increase the output impedance of a current source by compensating for the low intrinsic gain of a transistor were introduced to realize a high-frequency operational transconductance amplifier (OTA) for a low supply voltage using sub-100-nm CMOS processes. Applying these techniques, a MOS 7th-order Gm-C linear-phase low-pass filter (LPF) was realized using a 65nm CMOS process. A simplified biquad LPF that can serve as a component of a 7th-order LPF was newly developed by replacing OTAs with resistors. As a result, the -dB frequency bandwidth, group delay ripple, rd-order distortion, and rd-order input intercept point (IIP) were 200MHz, 2.2%, ≤ -55dB with a 100MHz input, and +10.dBm, respectively, all with a ±0.1Vp-p input signal at each input terminal in the pseudodifferential configuration. The LPF including an output buffer dissipated 60mW in the case of a 1.2V supply. Wide spurious-free dynamic range (SFDR) characteristics were confirmed up to high frequencies.

抄録全体を表示

In the 1993 Kushiro-oki Earthquake of Richter magnitude 7., simultaneous recording of earthquake motions was successfully made at the ground surface and at a depth of 77 meters in a dense saturated sand deposit. The peak horizontal acceleration was 0.47 g on the ground surface and 0.21 g at a depth of 77 meters. The acceleration record at the ground surface showed a distinctive ground response, which consisted of a cyclic motion having a period of about 1. seconds overlain by a spike at each peak of the motion. In order to study the mechanism of this peculiar ground response, effective stress analysis was conducted on the dense saturated sand deposit. The model used for this study was a strain space multiple mechanism model, which takes into account the effect of principal stress axis rotation. The recorded earthquake motion at a depth of 77 meters was used as the input earthquake motion for the analysis. Sampling after in-situ freezing was done in order to evaluate the properties of the sand. The results of the analysis indicated that the observed ground response was due to the effect of dilatancy of sand, which plays a significant role in the response of the dense saturated sand deposits during strong earthquake motions.

抄録全体を表示

Elastic wave propagation in saturated soil is investigated in order to grasp the frequency dependent wave propagation property of actual soil. First, a closed form solution of Biot's equation is derived under a one-directional wave propagation condition. Then, the frequency dependent properties of waves in various soils such as clay, silt, sand, gravel and soft rock are computed and discussed. The behavior is shown to be classified into three states : low frequency, high frequency and transient. Properties hardly change in the low and high frequency states. The degree of saturation is shown to hardly affect the shear wave property, but it greatly affects the dilatational wave property, especially in a highly saturated condition. Permeability hardly affects the properties at low and high frequency states, but it does change the frequency range of the transient state. Next, the applicability of Biot's formulation is examined and the high frequency state derived from Biot's equation is shown to be valid when permeability is larger than that of silt. Finally, it is shown that various mechanical properties can be evaluated using the frequency dependent characteristics of the wave, some of which are difficult to measure in situ with conventional tools.

抄録全体を表示