The possibility of attenuation of microseismic waves due to the presence of an upward folding of the ocean bottom into the liquid is discussed in this paper. The upward folding of the ocean bottom has been idealized by means of an irregularity in the form of a rectangle intruding into the liquid and the evaluation of the displacement component at any point of the solid medium has been carried out in two stages. First, the change in the incident mode of the surface wave due to the presence of the rectangular irregularity has been determined, and second, the subsequent change of the resulting displacement components due to the termination of the liquid layer and the step change in elevation of the solid medium at the continental margin has been discovered. Finally, numerical calculation has been made to determine the attenuation of the microseismic waves of different periods due to the presence of the rectangular irregularity at the ocean bottom.

抄録全体を表示

The ability of Climacodon septentrionalis to immobilize and kill a mycophagous nematode (Aphelenchoides sp.) in vitro is described for the first time. Two isolates produced droplets (20–45 μm in diameter) that formed at the apices of tall, stalked, and branching secretory cells (700–

,500 μm tall). On % modified malt extract agar, nematodes became enveloped in the droplets, which restricted their ability to move and resulted in complete immobilization and death within several hours of contact. The rate of decomposition of the nematodes varied considerably, with most individuals persisting for weeks whereas others were degraded within several days and appeared to be colonized by dense hyphal growth. This study provides the first documentation of a non-agaricoid fungus producing secretory cells that are able to immobilize nematodes.

抄録全体を表示

The effect of composition and controlled thermomechanical process parameters on the mechanical properties of HSLA steels is modelled using the Widrow-Hoff's concept of training a neural net with feed-forward topology by applying Rumelhart's back propagation type algorithm for supervised learning, using a Petri like net structure. The data used are from laboratory experiments as well as from the published literature. The results from the neural network are found to be consistent and in good agreement with the experimented results.

抄録全体を表示

An unsupervised learning technique and an associative memory have been used for encoding weights by a special type of Petri network named Petri neural net for modelling the influence of alloying elements on the final property of the high strength low alloy steel. The combined effects of alloying elements for different strengthening mechanisms is predicted when weights and threshold values are chosen on the basis of metallurgical understanding. The technique is found to be effective to create an associative memory of input-output relations in unknown data sets so that the same can be subsequently be used as a predictive tool.

抄録全体を表示

Primarily from the point of view of improvement of yield strength due to additions of niobium, titanium and boron in HSLA steels, the experimental steels are divided into five classes. The data are then supplied for learning a Self Organising Map (Kohonen network). It is found that the network with six neurons possesses better capacity of prediction with unknown data. Another effort of clustering the steels according to its major strength contributing mechanisms is also made. But the capacity of the network to cluster unknown data is found to be rather poor and has failed to follow from the metallurgical principles. To avoid this limitation, Learning Vector Quantisation method is adopted to impart a certain amount of supervision in the learning process and it is found that the training pattern of the network attains a good convergence thereby leading to a good predictive ability.

抄録全体を表示

A boron treated copper bearing HSLA steel containing austenite formers like manganese and nickel, somewhat lower in amount than that in HSLA 100 variety of steel is chosen for the study. The role of thermomechanical processing on the microstructure and mechanical properties of the above steel has been investigated. Differential scanning calorimetric study is carried out for understanding the precipitation behaviour of copper in HSLA steel under the influence of boron. The microstructure of the experimental steel is found to consist of laths of martensites and bainite. MA constituents of ribbon like morphology are observed at the lath boundaries. Higher strength properties of the steel are attributed to the presence of finely distributed precipitates of copper and microalloy carbides.

抄録全体を表示

Horizontal plate anchors are widely used in civil engineering constructions to resist vertical pulling loads. The available theoretical model suggested by Vesic to estimate the breakout resistance of plate anchors is in significant error, particularly for dense sandy soils. A theoretical model assuming a curved surface of failure through the surrounding soil, to evaluate the ultimate breakout resistance of horizontal plate anchors, has been proposed. It successfully brings out the concept of characteristics relative depth beyond which the breakout factor reaches a constant final value. It is capable of predicting breakout factors for wide range of values of angle of shearing resistance of sand.

抄録全体を表示

Simultaneous measurements of the total geomagnetic field intensity by the same type of the proton precession magnetometers at two stations in NW Turkey have been taken cooperatively by a research group since December 1970. Up to the end of July 1971 mainly three probable local magnetic changes were observed. It was seen that after a decrease in the local field at a magnetic station (Erdek) a few earthquakes occured at either nearly N or S of that station, and after an increase in the local field an earthquake took place nearly W of the same station. In this paper the data and some results of the first part of observations are given.

抄録全体を表示

Nine isoquinoline alkaloids belonging to the protoberberine, proaporphine and bisbenzyl-isoquinoline series were isolated from Caryomene olivascens (Menispermaceae). Four compounds are new : (-)--norlimacine (4), (-)-caryolivine (), (+)-, -dehydro--norlimacusine () and N-formylstepharine (). The last one is the first N-formyl derivative to be reported in the proaporphine group. Its biogenetic origin is discussed. Structures were established on the basis of 360 MHz (FT) nuclear magnetic resonance measurements and also by chemical correlation in the case of .

抄録全体を表示

We observed transients during the isotopic analysis of carbon dioxide, which could not be attributed to mixing processes because of their asymmetry, and to explain these we were led to consider the effects of diffusion on gas flow in the sample line. In particular, we investigated the propagation by diffusion of a concentration anomaly against a steady gas flow. If fractionation of isotopic(or chemical)species at the leak is to cause a change with time of the composition of the gas in the sample reservoir, then the effects of the fractionation must diffuse backwards as far as the gas reservoir.Using a one-dimensional Green's function, we obtained explicit analytical functions for the steady state concentration variation along a connecting tube between the leak and the reservoir, and for the composition variations with time at the leak. It is shown that the isotopic composition in the sample reservoir need not vary with time, even with a fractionating leak, provided that bulk gas velocity in the connecting tube is large enough. It is also shown that the diffusion process in combination with a fractionating leak can lead to the type of transients we observed.

抄録全体を表示

Since 135 years .C.H.Will Hamburg is one of the leading manufacturers of converting machinery for the paper industry.The company has gained worldwide acknowledgement when introducing cut size sheeters for copy paper. These machines are used worldwide by all well-known paper makers and also in the meantime by smaller paper converting companies.
With regard to folio size sheeter .C.H.Will was and is reknown for special solutions instead. Based on and with the knowhow of hundreds of cut size sheeters and some hundred folio size sheeters having been delivered, the concept of the Will “global folio size sheeter” type GFS has been developed.
The great technical experience in cutting and transporting paper as well as introducing innovative ideas, new materials and, last but not least, the influence of various customers' requests, which are known to .C.H.Will from numerous special projects, were the base for development of the GFS folio sheeter.

抄録全体を表示

飼育条件下におけるヨーロッパキダイDentex dentex仔稚魚の成長, 発育, 形態の変化を, 同一飼育群から連続的に採集した固定標本を用いて検討した。孵化仔魚は容の飼育槽でワムシ, アルテミア孵化幼生, 仔稚魚用配合飼料を用いて, 濾過海水 (塩分34-35) の流水, 18L: Dの人工照明条件下で集約的に飼育された。飼育期間中の水温は16.0から21.℃で推移した。孵化仔魚の平均全長 (TL) は.80±0.13mmで, 日令4-に摂餌を開始し, 日令 (.72±0.21mmTL, 167°D) で全個体が卵黄吸収を終了した。また油球の吸収は日令11 (206°D) であった。仔魚から稚魚への移行は日令27-34 (524-673°D) , 全長7.42-.00mmの個体の間で観察され, また初期発育段階における外部形態の変化に対応する成長屈曲点が相対成長に現れた。水温16.0-21.℃における飼育条件下でのヨーロッパキダイの初期発育段階の成長は, 次式で表すことができた。Y=-+0.1432X+.0000 (γ=0.967, n=1070, Yは全長mm, Xは日令) 。

抄録全体を表示