A sample of [³H] tobrarnycin (, 000 Ci/Mole) has been synthetized and incubated with
the bacterial ribosome and its subunits. The results obtained show that this antibiotic has
two types of binding sites. The primary one is probably responsible for the inhibition of
protein synthesis whereas the secondary one is probably related to the misreading and reading
tiirough of the messenger RNA.

抄録全体を表示

(³H) Tobramycin was used as a probe to determine the relationship between the structure of aminoglycoside antibiotics and their ability to remove this drug from its higher affinity binding site on the ribosome. The dissacharide moieties (neamine, tobramine, gentamine) appeared to have a common binding site, whereas the kanosamine, garosamine and ribose moieties determined the specificity of this binding. Amikacin and butikacin behaved in an anomalous manner in spite of their close structural relationship to tobramycin.

抄録全体を表示

The activities of tobramycin derivatives acetylated and ethylated on the 6'-N, '-N and 3-N positions were examined. The MICs of these derivatives against tobramycin sensitive strains indicated that '-N-ethylated and 6'-N-ethylated derivatives have a fairly good activity, and confirmed that the 3-N position is the most important one for antibiotic activity since 3-N derivatives were less active. The MICs of these derivatives against tobramycin resistant strains, and their inactivation by tobramycin modifying enzymes were examined. These results showed that '-N or 6'-N ethylation protects the drug against inactivation by AAC(') or AAC(6'), respectively, and '-N-ethyltobramycin and 6'-N-ethyltobramycin were active against strains containing these modifying enzymes. On the other hand, 3-N ethylation protects the drug against inactivation by AAC(3) but 3-N-ethyl tobramycin does not inhibit strains containing this enzyme.

抄録全体を表示

A comparative study of the static and dynamic response of a slope is carried out, using the large deformation theory of the updated Lagrangian formulation and the conventional infinitesimal theory. In the static analysis, a strength reduction method proposed by one of the authors is used to evaluate the safety factor of the slope. It is found that by the large deformation theory, the safety factor is larger than that calculated by the infinitesimal theory, and this difference becomes large along with the reduction of elastic modulus. In the dynamic analysis, it is observed that the large deformation theory gives smaller sliding displacement and larger response acceleration than the infinitesimal approach. It is concluded that in many cases the large deformation approach gives more adequate solutions.

抄録全体を表示

Based on the concept "intermediate soil wedge" which is dependent on mobilized frictional resistance, a new theory has been developed for evaluating the seismic earth pressures against retaining walls under any condition between the active and passive states. For this theory, the seismic earth pressure is separated into four components according to their formation. New equations are proposed to determine the distribution, resultant and point of application for each component. An equivalent seismic coefficient is introduced to take into account non-uniform seismic acceleration distribution with depth. The equations place special emphasis on dependence of the seismic earth pressure on mode and level of wall movement. The equations can be reduced to the Mononobe-Okabe equation for the limiting conditions. Their applicability was confirmed by comparing the predictions with a number of previous model test results.

抄録全体を表示

A finite element model capable of taking into account nonlinear hysteretic soil behavior is presented to study earthquake induced retaining wall movement. The model also accounts for increase in lateral stresses and settlement associated with grain slip caused by cyclic loads. The predictive capability of the proposed method is verified by comparing responses given by the model with those computed by another existing finite element model and also with responses recorded at the Cambridge centrifuge facility. The study reveals that the wall displacement can be substantially affected, among other factors, by the increase in lateral stresses due to grain slip and wall-soil friction. Care should be taken when selecting a constant value of wall-soil friction angle for the entire duration of excitation since structural changes can occur in the soil adjacent to the wall.

抄録全体を表示

The ability of Climacodon septentrionalis to immobilize and kill a mycophagous nematode (Aphelenchoides sp.) in vitro is described for the first time. Two isolates produced droplets (20–45 μm in diameter) that formed at the apices of tall, stalked, and branching secretory cells (700–

,500 μm tall). On % modified malt extract agar, nematodes became enveloped in the droplets, which restricted their ability to move and resulted in complete immobilization and death within several hours of contact. The rate of decomposition of the nematodes varied considerably, with most individuals persisting for weeks whereas others were degraded within several days and appeared to be colonized by dense hyphal growth. This study provides the first documentation of a non-agaricoid fungus producing secretory cells that are able to immobilize nematodes.

抄録全体を表示

Leakage of water due to internal erosion through a dam body or foundation is a major problem with fill-type dams. Recent case histories and research suggest that most cases of internal erosion are possibly triggered by hydraulic fracturing. However, the quantitative mechanism of hydraulic fracturing still remains to be solved. Therefore in-situ hydraulic fracture tests were carried out with a cheap, concise apparatus using boreholes dug in the soft clayey volcanic soil foundation of a low earth dam (Oyachi Dam) in Niigata Prefecture. Water was injected into the foundation through a perforated pipe by two methods : one was under a controlled injection pressure and the other was a controlled injection flow rate. In the former method, the relationship between flow rate and injection pressure was observed and it was found that a yield pressure or fracture pressure existed in all the tests. By repeating the injection test it was confirmed that once a crack is developed, it is very easily reopened by a water pressure a little higher than the earth pressure exerted on the crack. In the latter method, the relationship between injection pressure and time was observed and it was found that fracture pressure varied with flow rate. The boreholes were excavated to observe the development of fracture cracks and it was also found that the cracks had developed perpendicular to the borehole periphery, which means that fracture cracks were induced by tensile stress and denies the explanation that fractures are caused by shear failure.

抄録全体を表示

During earthquakes, saturated loose sandy soils often liquefy, causing serious damage to buildings and underground structures. Various construction methods have been employed to stabilize these soils against liquefaction. The popular methods are those which increase their density. Vibration and impact methods are commonly employed, but these often pose a problem of noise and vibration in urban areas. Results of previous experiments have shown that Quick Lime Consolidated Briquettes (QCB), a soil stabilizer made of quicklime and cement placed to form cylinders, significantly increases resistance to liquefaction by utilizing the effects of water absorption, swelling, and hardening. In the present study, shaking table tests were performed to evaluate the earthquake resistance of soil treated with QCB. Results of these test showed that the response acceleration and excess pore water pressure in QCB-treated soils were scarcely affected by the excitation of 200 Gals. The soil settlement due to shaking was about one tenth of that for the untreated soil, proving the effectiveness of QCB during earthquakes.

抄録全体を表示

The mechanism of wave-induced instability in a permeable seabed have been studied for more than two decades. The distinction between shear failure and liquefaction, however, has not been clearly defined. This paper presents a fundamental study on the differences in two failure modes for a fully saturated seabed of both finite and infinite thickness. The wave-induced effective stresses and pore pressure, obtained from an analytical solution of Biot's pore-elastic consolidation theory, were employed to examine the failure modes under a two-dimensional plane strain condition. A case study is presented to examine the failure modes with respect to several parameters, such as excess pore pressure, seepage flow, seepage force, failure areas and stress path in the seabed. The conclusions obtained from this study were as follows ; () the thickness of a permeable seabed affects the pore pressure and effective stress response to ocean waves and the failure mode of the seabed, () either a liquefaction or shear failure, or both, occur in the seabed, even in the saturated seabed, (3) the Mohr-Coulomb's failure criterion, when combined with elastic stresses, can not be employed to estimate the liquefaction failure in the seabed, (4) the liquefaction can be evaluated by a criterion in terms of the excess pore pressure, () The liquefied zone in the seabed is significantly different from the shear failure zone. The shape beneath the seabed surface for the former is almost identical to the contour where the upward seepage flow is concentrated.

抄録全体を表示

This paper concerns the stability against overturning of the caissons on rubble mound subjected to wave loading. A theoretical discussion is first made of the stability of a leaning caisson during wave loading, as a single degree-of-freedom system. The expression for the lower bound of driving moments sufficient to overturn a given caisson is derived. A review is then made of the damages induced to a composite breakwater, which consisted of two adjoining Stretches and with slightly different sizes of caissons. Attention is called for the observation that most of the caissons in Stretch were overturned, whereas no caissons in Stretch were brought into overturning. This fact is examined in detail in the light of the theory of overturning, making it possible to estimate the destructive wave heights that are compatible with the observed patterns of damage in Stretches and of the composite breakwater.

抄録全体を表示

The behavior of the soft clay grounds subjected to repeated loading is different from that subjected to sustained loading. The difference in settlement between these two loading patterns should be due to secondary compression over a long period of time. Consequently, soft clay grounds subjected to repeated loading tend to be more compressible than those subjected to sustained loading. Therefore, it is necessary for engineers to predict post-construction settlements under repeated loading. In this respect, the preloading is considered to be promising as a countermeasure to reduce the settlement of clay under repeated loading as well as under sustained loading. The effect of preloading on post-construction consolidation settlement of soft clay subjected to repeated loading after removal of a part of preload is investigated in the present paper. It has become clear that the settlement of a clay sample after preconsolidation is mainly affected by the amount of preload, the degree of consolidation due to the preload, the amount of permanent load and the amount of repeated load after removal of preload. The calculated settlement versus time relations using a method to estimate the amount of consolidation settlement of soft clay grounds subjected to repeated loading after removal of preloading were compared with the observed degree of consolidation as parameters of the intensities of preload and repeated load.

抄録全体を表示

An analytical measure was developed so that the permanent displacement/deformation caused by seismic subsoil liquefaction can be predicted. Since the effects of topography on displacement is important, a three-dimensional analysis was developed which can fully consider the topography. Moreover, the loss of resistance in the surface unliquefied crust undergoing a tensile stress was taken into account. The empirical interpolation of the lateral displacement along the vertical axis helped reduce the amount of computation. Consequently, a finite-element two-dimensional analysis which is equivalent to a three-dimensional calculation was developed. The displacement obtained by the proposed method is the maximum possible to minimize the potential energy of the subsoil. By comparing the calculated displacement with the observation, the predicted displacement was to some extent greater than the observation. Hence, a dynamic analysis in the time domain, which was also developed by the authors, is necessary for a better matching between prediction and observation. In contrast, the direction of displacement was correctly predicted by the present analysis.

抄録全体を表示

Field data indicate that the P-wave velocity in sand or gravel is sometimes much lower than that of water, even if the soil is below the water table. It is well understood that a slight decrease in saturation normally evaluated by the -value has a significant effect on undrained shear behavior like liquefaction of saturated soil. In the first part of this research, theoretical formulations of the -value, P-wave velocity and Poisson's ratio are made by taking into account the decrease in bulk modulus of water due to a mixture of air bubbles. Then, computations are carried out using formulas based on the soil properties of a typical sand or gravelly soils and Masa soil from the Kobe area to make charts correlating the variables. These charts indicate that a small decrement in the -value in the interval of =. to . will considerably decrease the P-wave velocity. Thus, the P-wave velocity which is easily measured in the field can serve as a convenient index to quantitatively evaluate the insitu soil -value.

抄録全体を表示

Circuit techniques to enhance the linearity of input-voltage-to-current (V/I) conversion and to increase the output impedance of a current source by compensating for the low intrinsic gain of a transistor were introduced to realize a high-frequency operational transconductance amplifier (OTA) for a low supply voltage using sub-100-nm CMOS processes. Applying these techniques, a MOS th-order Gm- linear-phase low-pass filter (LPF) was realized using a 65nm CMOS process. A simplified biquad LPF that can serve as a component of a th-order LPF was newly developed by replacing OTAs with resistors. As a result, the -3dB frequency bandwidth, group delay ripple, 3rd-order distortion, and 3rd-order input intercept point (IIP3) were 200MHz, .%, ≤ -55dB with a 100MHz input, and +10.3dBm, respectively, all with a ±.Vp-p input signal at each input terminal in the pseudodifferential configuration. The LPF including an output buffer dissipated 60mW in the case of a .V supply. Wide spurious-free dynamic range (SFDR) characteristics were confirmed up to high frequencies.

抄録全体を表示

The Nihonkai-chubu Earthquake, with a magnitude of ., occurred on May 26, 1983 in northwest Japan and produced liquefaction sites in the coastal plain of Akita and Aomori Prefectures. About one month later, the maximum aftershock, with a magnitude of ., again induced liquefaction at several sites in Aomori Prefecture. The authors surveyed the affected area and discovered almost ten reliquefaction sites. Initial liquefaction at these sites had not occurred solely because of the main shock of the Nihonkai-chubu Earthquake. Initial liquefaction at some sites was attributable to the Niigata Earthquake in 1964, the Tokachi-oki Earthquake in 1968, and other earlier earthquakes. Although it had earlier been thought that the occurrence of reliquefaction would be improbable, the authors' investigation shows that reliquefaction occurs frequently, even when the acceleration caused by a later earthquake was less than that caused by a former earthquake. It can therefore be said that a site liquefied by an earthquake can be reliquefied by a subsequent earthquake.

抄録全体を表示