The design implication of stress-confinement effect of nonwoven geotextile is addressed. The unconfined and confined strengths of a selected needle-punched nonwoven geotextile are used to conduct a comparative design of a granular soil retaining wall based on a limit equilibrium approach. A higher wall may be allowed when considering the confined strength as compared to the unconfined strength. For a selected wall height, confined strength allows for fewer geotextile layers when compared to that designed using unconfined strength. It is recommended that stress-confinement test procedure should be standardized so that confinement effect of some nonwoven geotextiles may be incorporated into an individual wall design procedure.

抄録全体を表示

The gamma-ray spectrum and the conversion-electron spectrum are measured in the decay of the ^116mIn activity. Directional correlations are also measured for 818–1293 and 1097–1293 keV cascades. The M1-2 mixing ratio δ, and the -2 mixing ratio μ_k are obtained for 818. keV +→2₁⁺ transition to be δ=1.52−

0.22

+

0.26

, and μ_k≤6.1×10⁻⁴ respectively. The

E

2 branching ratio B(

E

2;

2₂

+→

0_g

+): B(

E

2;

2₂

+→2₁⁺): B(

E

2;

2₂

+→0₁⁺) is determined to be

0

.0158:1.

0

:

5

.

86

.

抄録全体を表示

It has been shown after mathematical and mechanical investigation that Limit Equilibrium Method (LEM) can be considered as a method to obtain the necessary condition of Slip Line Method (SLM), and that the solution can be obtained under the condition that F_s=1 and ∂F_s/∂θ=O, where F_s is the safety factor and θ is the inclination of the plane on which the safety factor is defined. Next, the generalized LEM (GLEM) is proposed, dealing with the following points : (1) Triangular or quadrangular blocks can be treated; (2) Safety factors are defined also on interblock planes; and (3) All types of plastic problems, slope stability, bearing capacity, and earth pressure are identically formulated. Two situations regarding treatment of the moment equilibrium condition are discussed. GLEM is applied to well-known problems. The results agree well with those obtained by theoretical methods. GLEM can be used to obtain the distribution of earth pressure or bearing capacity. GLEM, Iike ordinary LEM, is very effective for the practical problems, but GLEM is more theoretical and it can result in more accurate solutions.

抄録全体を表示

The ability of Climacodon septentrionalis to immobilize and kill a mycophagous nematode (Aphelenchoides sp.) in vitro is described for the first time. Two isolates produced droplets (20–45 μm in diameter) that formed at the apices of tall, stalked, and branching secretory cells (700–1,500 μm tall). On 2% modified malt extract agar, nematodes became enveloped in the droplets, which restricted their ability to move and resulted in complete immobilization and death within several hours of contact. The rate of decomposition of the nematodes varied considerably, with most individuals persisting for weeks whereas others were degraded within several days and appeared to be colonized by dense hyphal growth. This study provides the first documentation of a non-agaricoid fungus producing secretory cells that are able to immobilize nematodes.

抄録全体を表示

The Tsukuba Challenge is a competition, in which autonomous mobile robots run on a route set on a public road under a real environment. Their task includes not only simple running but also finding multiple specific persons at the same time. This study proposes a method that would realize person searching. While many person-searching algorithms use a laser sensor and a camera in combination, our method only uses an omnidirectional camera. The search target is detected using a convolutional neural network (CNN) that performs a classification of the search target. Training a CNN requires a great amount of data for which pseudo images created by composition are used. Our method is implemented in an autonomous mobile robot, and its performance has been verified in the Tsukuba Challenge 2017.

抄録全体を表示

We screened the differentiation-inducing activities of 39 mushroom extracts from Akita prefecture, Japan, on the mouse osteoblastic cell line, MC3T3-1. Sixteen phosphate buffered saline (PBS), 8 boiled PBS, 14 ethanol and 12 methanol extracts induced alkaline phosphatase (ALP) activities, an indicator of MC3T3-1 cell differentiation. The enzyme activities were markedly induced by extracts of Tricholoma auratum, and we isolated the active compound from methanol extracts of this mushroom. Physical data for the isolated active compound were identical to those for (,24R)-ergosta-,-diene-3β,,6β-triol (1). 1 induced ALP activities of MC3T3-1 cells and promoted cell proliferation. To investigate the relationships between the chemical structure and differentiation-inducing activity of the compound, ALP-inducing activities of MC3T3-1 cells by 1, ergosterol (2), ergocalciferol (3), cholesta-3β,,6β-triol (4), -dehydrocholesterol () and cholecalciferol (6) were tested. The enzyme activities of MC3T3-1 cells were increased 3.-fold by 10 μM 1 and 2.4-fold by 10 μM 4. However, 2, 3, and 6 did not induce MC3T3-1 cell ALP activity at .1—10 μM. These results suggested that the OH groups at C- and/or C-6 of 1 and 4 played an important role in their differentiation-inducing activities on MC3T3-1 cells. Furthermore, 1 suppressed induction of MC3T3-1 cell apoptosis by serum starvation.

抄録全体を表示

Circuit techniques to enhance the linearity of input-voltage-to-current (V/I) conversion and to increase the output impedance of a current source by compensating for the low intrinsic gain of a transistor were introduced to realize a high-frequency operational transconductance amplifier (OTA) for a low supply voltage using sub-100-nm CMOS processes. Applying these techniques, a MOS th-order Gm-C linear-phase low-pass filter (LPF) was realized using a 65nm CMOS process. A simplified biquad LPF that can serve as a component of a th-order LPF was newly developed by replacing OTAs with resistors. As a result, the -3dB frequency bandwidth, group delay ripple, 3rd-order distortion, and 3rd-order input intercept point (IIP3) were 200MHz, 2.2%, ≤ -55dB with a 100MHz input, and +10.3dBm, respectively, all with a ±.1Vp-p input signal at each input terminal in the pseudodifferential configuration. The LPF including an output buffer dissipated 60mW in the case of a 1.2V supply. Wide spurious-free dynamic range (SFDR) characteristics were confirmed up to high frequencies.

抄録全体を表示

Alfven resonance effects on the evolution of a magnetic island driven by an externally applied perturbation are investigated for rotating plasmas. The simulation results show the importance of Alfven resonance for obtaining a perturbed current profile and estimating a critical value of the external perturbation, beyond which the magnetic island grows rapidly. The nonlinear evolution of the externally driven magnetic island is also investigated at low and high viscosities ν. It is shown that the transition phase accompanying the secondary reconnection at the initial X-point in the driven magnetic island evolution occurs in low resistivity and viscosity plasmas.

抄録全体を表示

2014年LIA法を原理とする血清H. pylori抗体価測定キット「LZテスト」が上市された。LZテストは従来のELISA法によるプレートとは異なる測定系であり, プレートに関する知見が通用する保証はない。今回, LZテストの陰性高値(抗体価3.～.U/ml)がプレートと同様の取扱いができるかを検証した。対象は両検査法で抗体価を同時測定し両抗体価の少なくとも一方が10U/ml未満であった230例であり, 陰性高値内のH. pylori感染状態の構成比および“新ABC分類”(カットオフ値＝3.U/ml)による分類結果を比較した。プレートでは陰性高値となる未感染は存在せず, LZテストでは16例(.%)であった。未感染例に新ABC分類を適応するとプレートではA群97例(99.%)D群1例(1.%), LZテストではA群例(84.%), BCD群合わせて15例(15.3%)であった。LZテストの陰性高値には未感染が多く含まれ, 新ABC分類をLZテストで行うと未感染者を要精検とする割合が増えるため, 未感染者が多数を占める検診ではプレートを用いることが望ましい。

抄録全体を表示

Purpose: This study aims to evaluate the effect of different glazing methods on translucency parameter (TP), contrast ratio (CR), opalescence parameter (OP), surface roughness (Ra) and topography of the silicate ceramics.

Methods: Seventy specimens (10 ×10 ×1 mm) were fabricated from lithium disilicate (IPS

.max CAD, abbreviated as ) and zirconia-reinforced lithium silicate (Vita Suprinity, abbreviated as VS) ceramics and divided into subgroups (n = 10) according to the polishing and glazing procedures: (1) mechanical polishing before-crystallization (m-), (2) mechanical polishing after-crystallization (m-), (3) glaze powder/liquid after-crystallization (pl-), (4) glaze-paste before-crystallization (gp-), () glaze-paste after-crystallization (gp-), (6) glaze-spray before-crystallization (gs-), () glaze-spray after-crystallization (gs-). Color and Ra measurements were performed. CIEL*a*b* and CIEXYZ parameters were recorded and TP, CR, and OP values were calculated. Data were analyzed using two-way ANOVA and Tukey HSD tests (α = .05).

Results: In

groups, the highest Ra value was found in gs- (1.66 ± .14 μm) while the lowest value was found in pl- (.68 ± .08 μm). In VS groups, the highest Ra value was found in gp- (1.64 ± .25 μm) while the lowest value was found in m- (.77 ± .06 μm) (p < .05). The mean TP value of (17.62 ± .73) was found to be higher than VS (15.37 ± 1.16). The CR (.72±.030) and OP (12.06 ± .74) values of VS were found higher than CR (.57 ± .02) and OP (6.72 ± .40) values of .

Conclusions: Zirconia-reinforced silicate ceramics have higher opalescence and lower translucency values than lithium disilicate ceramics. Increase in surface roughness reduces translucency. Glaze powder/liquid after-crystallization is the most effective way to reduce surface roughness of lithium disilicate ceramics while that is mechanical polishing after-crystallization for zirconia-reinforced silicate ceramics.

抄録全体を表示

Activity-directed isolation of the ethyl acetate, methylene chloride and n-hexane fractions of Gloiopeltis furcata resulted in the isolation of 18 compounds. Their structures were elucidated as 2-(3-hydroxy--oxotetrahydrofuran-3-yl)acetic acid (1), glutaric acid (2), succinic acid (3), nicotinic acid (4), ()-4-hydroxyhex-2-enoic acid (), cholesterol (6), -hydroxycholesterol (), uridine (8), glycerol (), -(hydroxymethyl)-2-methoxybenzene-1,3-diol (10), (,)--oxodeca-,-dienoic acid (11), (Z)-3-ethylidene-4-methylpyrrolidine-2,-dione (12), dehydrovomifoliol (13), loliolide (14), cholesteryl stearate (15), palmitic acid (16), cis-,8,11,14,17-eicosapentaenoic acid (17) and α-linolenic acid (18) on the basis of spectroscopic and chemical evidences. Their anticholinesterase and antioxidant activities were evaluated via inhibitory activities on acetylcholinesterase (AChE) and butyrylcholinesterase (BChE) as well as scavenging activities on 1,1-diphenyl-2-picrylhydrazyl (DPPH) radical and peroxynitrite (ONOO⁻). All isolated compounds (1—18) exhibited moderate AChE inhibitory activities with IC₅₀ values ranging from 1.14—12.50 μg/ml, whereas 1, , , 17, and 18 showed mild BChE inhibitory activities with IC₅₀ values ranging from .57—15.89 μg/ml. Although most of the compounds isolated were lacking the scavenging activity on DPPH radical and ONOO⁻, and 10 showed good DPPH radical scavenging activity, and , 10, and 16 showed potent ONOO⁻ scavenging activity.

抄録全体を表示

In the first part of the present work the interaction of glycophorin with dimyristoylphosphatidylcholine (DMPC) is studied by freeze fracture electron microscopy, densitometry, calorimetry, and 90° static light scattering. An exothermic lipid/protein interaction energy of W_P=190 kJ•mol^-1 was found by application of the well known Van Laar relation for the displacement of the freezing point and the Gibbs-Duhem relationship. Secondly, the effects of Ca²⁺ on the lipid/protein interaction were studied. Following Ca²⁺ addition a remarkable decoupling of the interaction of the glycophorin head group with the bilayer surface was revealed by densitometry and gold-labeling electron microscopy. It is estimated that about % of lipid once disturbed by the adsorption of glycophorin head groups is decoupled after addition of Ca²⁺. Thirdly, the selective interaction of glycophorin with binary lipid mixtures was studied, including the mixtures of DMPC with dimyristoylphosphatidylserine (DMPS) and dilauroylphosphatidylcholine (DLPC), and the mixture of dipalmitoylphosphatidylcholine (DPPC) with DLPC.

抄録全体を表示