A comparative study of the static and dynamic response of a slope is carried out, using the large deformation theory of the updated Lagrangian formulation and the conventional infinitesimal theory. In the static analysis, a strength reduction method proposed by one of the authors is used to evaluate the safety factor of the slope. It is found that by the large deformation theory, the safety factor is larger than that calculated by the infinitesimal theory, and this difference becomes large along with the reduction of elastic modulus. In the dynamic analysis, it is observed that the large deformation theory gives smaller sliding displacement and larger response acceleration than the infinitesimal approach. It is concluded that in many cases the large deformation approach gives more adequate solutions.

抄録全体を表示

Based on the concept "intermediate soil wedge" which is dependent on mobilized frictional resistance, a new theory has been developed for evaluating the seismic earth pressures against retaining walls under any condition between the active and passive states. For this theory, the seismic earth pressure is separated into four components according to their formation. New equations are proposed to determine the distribution, resultant and point of application for each component. An equivalent seismic coefficient is introduced to take into account non-uniform seismic acceleration distribution with depth. The equations place special emphasis on dependence of the seismic earth pressure on mode and level of wall movement. The equations can be reduced to the Mononobe-Okabe equation for the limiting conditions. Their applicability was confirmed by comparing the predictions with a number of previous model test results.

抄録全体を表示

During earthquakes, saturated loose sandy soils often liquefy, causing serious damage to buildings and underground structures. Various construction methods have been employed to stabilize these soils against liquefaction. The popular methods are those which increase their density. Vibration and impact methods are commonly employed, but these often pose a problem of noise and vibration in urban areas. Results of previous experiments have shown that Quick Lime Consolidated Briquettes (QCB), a soil stabilizer made of quicklime and cement placed to form cylinders, significantly increases resistance to liquefaction by utilizing the effects of water absorption, swelling, and hardening. In the present study, shaking table tests were performed to evaluate the earthquake resistance of soil treated with QCB. Results of these test showed that the response acceleration and excess pore water pressure in QCB-treated soils were scarcely affected by the excitation of 200 Gals. The soil settlement due to shaking was about one tenth of that for the untreated soil, proving the effectiveness of QCB during earthquakes.

抄録全体を表示

A finite element model capable of taking into account nonlinear hysteretic soil behavior is presented to study earthquake induced retaining wall movement. The model also accounts for increase in lateral stresses and settlement associated with grain slip caused by cyclic loads. The predictive capability of the proposed method is verified by comparing responses given by the model with those computed by another existing finite element model and also with responses recorded at the Cambridge centrifuge facility. The study reveals that the wall displacement can be substantially affected, among other factors, by the increase in lateral stresses due to grain slip and wall-soil friction. Care should be taken when selecting a constant value of wall-soil friction angle for the entire duration of excitation since structural changes can occur in the soil adjacent to the wall.

抄録全体を表示

This study was performed to clarify which factors affected damage to tame-ike (small embankment dams for irrigation) in Hokudan Town as a result of the January 17, 1995 Hyogoken-Nambu earthquake. Factors were assumed to be : Location (.g., Distance to Epicenter, etc.), Structure (.g., Angle to Nearest Fault, Embankment Volume, etc.), Soil Properties of Embankment, Geology of Dam Site and History (Era of Construction, Repaired, etc.). Multivariate statistical analyses were performed for documentary data (damaged : 181, undamaged : 328). Ordinary statistical analyses were conducted for the data investigated in situ for soil properties of the embankment. The results show that the factors causing damage to dam are : (1) Nearest Fault (Nojima, Mizukoshi and D2), (2) Distance to Nearest Fault (less than 500 m), (3) Distance to Epicenter (approximately to 14 km, which almost agrees with the location of seismic intensity 7 JMA), () Elevation of Dam Site (higher than 100 m), () Embankment Volume (the greater the volume the more damage was caused), () Direction of Dam Axis (normal or diagonal to the epicenter or to nearest the fault), (7) Plan View of Dam Axis (3 or axes), () Surface Geology of Dam Site (non-cohesive soil type ground), (9) Era of Construction (prior to 1891) and (10) Soil Properties of Embankment (sand, not silty sand or gravel, penetration resistance that is 10% smaller than the undamaged dams).

抄録全体を表示

The gamma-ray spectrum and the conversion-electron spectrum are measured in the decay of the ^116mIn activity. Directional correlations are also measured for 818–1293 and 1097–1293 keV cascades. The M1-2 mixing ratio δ, and the 0-2 mixing ratio μ_k are obtained for 818.7 keV +→2₁⁺ transition to be δ=1.52−

0.22

+0.26, and μ_k≤

6

.1×10−

4

respectively. The

E

2 branching ratio B(

E

2;

2₂

+→0_g⁺): B(

E

2;

2₂

+→2₁⁺): B(

E

2;

2₂

+→0₁⁺) is determined to be 0.0158:1.0:

5

.

86

.

抄録全体を表示

The syntheses of (S)-13-hydroxy-(2, , )-tetradecatrienoic acid (1) and (2, , Z-tetradecatrienoic acid (2) were carried out by using the Wittig reaction as the key step. The asymmetric center at C-13 and the double bond between C- and C-9 for natural compound 1 were reconfirmed as being of (S) configuration and , respectively. The relationship between the structure of the unsaturated hydroxy fatty acids and their inhibitory effect on the growth of lettuce was investigated.

抄録全体を表示

Circuit techniques to enhance the linearity of input-voltage-to-current (V/I) conversion and to increase the output impedance of a current source by compensating for the low intrinsic gain of a transistor were introduced to realize a high-frequency operational transconductance amplifier (OTA) for a low supply voltage using sub-100-nm CMOS processes. Applying these techniques, a MOS 7th-order Gm-C linear-phase low-pass filter (LPF) was realized using a 65nm CMOS process. A simplified biquad LPF that can serve as a component of a 7th-order LPF was newly developed by replacing OTAs with resistors. As a result, the -3dB frequency bandwidth, group delay ripple, 3rd-order distortion, and 3rd-order input intercept point (IIP3) were 200MHz, 2.2%, ≤ -55dB with a 100MHz input, and +10.3dBm, respectively, all with a ±0.1Vp-p input signal at each input terminal in the pseudodifferential configuration. The LPF including an output buffer dissipated 60mW in the case of a 1.2V supply. Wide spurious-free dynamic range (SFDR) characteristics were confirmed up to high frequencies.

抄録全体を表示

Two new polyacetylene compounds (, , 12)-1-acetoxy-3-isovaleryloxytetradeca-, , 12-trien-, 10-diyn-14-ol (B), and (, , 12)-1-acetoxy-3-(2-methylbutyryloxy)tetradeca-, , 12-trien-, 10-diyn-14-ol (C) have been isolated along with (, , 12)-1-acetoxy-3-senecioyloxytetradeca-, , 12-trien-, 10-diyn-14-ol (A) from Atractylodes Rhizome (Karabyakujutu). The structures of these compounds were determined on the basis of their spectral data.

抄録全体を表示

The objective of this article is to propose and evaluate a sliding-block model to deal with very large displacements of slopes when a horizontal earthquake is applied. The slip surface consists of two inclinations on which full shear resistance is mobilized. Internal shearing exists along a sub-plane that intersects the angle between the two sub-planes that form the external slip surface. The ratio of the distance moved along the two external sub-planes depends on the inclination of the internal sub-plane. If there is a water table line, undrained conditions are assumed during motion and total stress analysis is performed. The governing equations of motion are formulated, analytical solutions are obtained for some cases, and back-analysis of four well-documented slides is performed.

抄録全体を表示

This paper is concerned with an extension of a rotational limit equilibrium method for determining the permanent displacements of slopes under seismic excitation. In the proposed procedure, the sliding mass is treated as a rigid rotating body defined by a log spiral trace. Permanent displacements are obtained by double-integration of the equation of motion in a manner similar to Newmark's translational sliding block method. The seismic slope stability analysis is based on the rotational (variational) limit equilibrium approach. This stability analysis was verified with dynamic experimental results obtained from centrifuge model testing. A series of parametric studies was conducted on"unstable"slopes, investigating the effects of soil properties and characteristics of excitation on the magnitude of permanent displacements. The higher the frictional angle, the smaller the permanent displacement of the slope is. Low excitation frequency yields larger slope displacement if the excitation is extended for the same time period of time. The effect of frequency becomes less distinct when a larger value of yield seismic coefficient is used. The proposed procedures produce a rational criterion to evaluate the seismic performance of simple slopes. This criterion is based on permanent displacement limit rather than factor of safety alone.

抄録全体を表示

In the seismic analysis of pile foundations the soil is often assumed to be an elastic material and the pressure at the soil pile interface is not limited during the analysis. This may result in a considerable error, as the computed pressure from an elastic analysis may go well beyond the ultimate lateral pressure of real soil. In fact, significant yielding at the soil-pile interface has been observed during real earthquakes, and also in laboratory tests. The yield zone is usually near the ground surface where the effect of inertial force due to the superstructure is higher. This yielding redefines the pile response, and in general cannot be ignored. In order to examine the effects of soil yielding on the internal pile response during earthquakes an approximate analysis is described in this paper which is an extension of a static method developed by the second author (1982) for the analysis of piles subjected to lateral soil movement. This method is then used to investigate the effects of soil yielding on the internal response of piles through a comparative study in which real earthquakes are used. It is shown that for strong earthquakes and heavily loaded piles the soil yielding may considerably increase the amount of maximum pile moment developed in the pile. A marked difference in the effects of yielding on the pile moment and shear is observed and discussed.

抄録全体を表示

The interaction between a penetrating shaft and the surrounding soil media under impact loading is a frequently encountered phenomenon in geotechnical engineering. Examples of such dynamic soil/shaft interaction would include dynamic pile driving, standard penetration testing (SPT), and dynamic driven rod test. Presented in this paper is a novel approach, based on the principle of dynamic system identification, which enables identification of dynamic soil-pile interaction model parameters. The analytical transfer function, relating the output stress wave forms to the input stress wave forms in the soil/shaft system, is derived using the Laplace and Fourier Transform techniques and the one-dimensional wave propagation theories. A numerical solution algorithm based on a variation of gradient method is coded into a micro-computer based program to solve the frequency-dependent soil-pile interaction parameters (Smith model) : soil damping and soil spring stiffness. To further reduce the amount of computational effort required in the solution of the frequency-dependent dynamic soil properties, it is suggested that the solution be obtained for the first-mode natural frequency of the measured stress waves. The results obtained from this simplified solution algorithm, when compared with both numerical simulations and controlled laboratory tests, are reasonably acceptable. The proposed parameter identification technique offers a viable alternative data interpretation procedure for deducing pertinent Smith model parameters used frequently in pile driving analysis.

抄録全体を表示

Some existing analytical methods which have been used in geotechnical engineering are modified to handle the shear strength reduction with time due to softening in fissured, over-consolidated clays and mudstones. These are limit equilibrium analysis of slope stability, calculation of earth pressure and calculation of stress and displacement around a tunnel. The softening effect is incorporated in these analyses using the failure criterion and the time-dependent strength parameters proposed previously by the authors. Examples are presented which emphasize the importance of appreciating the softening effect in analyses and further illustrate that the effect of shear strength reduction with time due to softening could easily be captured with existing analytical methods.

抄録全体を表示

It has been shown after mathematical and mechanical investigation that Limit Equilibrium Method (LEM) can be considered as a method to obtain the necessary condition of Slip Line Method (SLM), and that the solution can be obtained under the condition that F_s=1 and ∂F_s/∂θ=O, where F_s is the safety factor and θ is the inclination of the plane on which the safety factor is defined. Next, the generalized LEM (GLEM) is proposed, dealing with the following points : (1) Triangular or quadrangular blocks can be treated; (2) Safety factors are defined also on interblock planes; and (3) All types of plastic problems, slope stability, bearing capacity, and earth pressure are identically formulated. Two situations regarding treatment of the moment equilibrium condition are discussed. GLEM is applied to well-known problems. The results agree well with those obtained by theoretical methods. GLEM can be used to obtain the distribution of earth pressure or bearing capacity. GLEM, Iike ordinary LEM, is very effective for the practical problems, but GLEM is more theoretical and it can result in more accurate solutions.

抄録全体を表示

By employing an undrained cyclic loading ring-shear apparatus, a series of tests to reproduce the dynamic behavior of the Nikawa landslide induced by the January 17, 1995 Hyogoken-Nambu earthquake, is conducted. The test sample is Osaka-group coarse sandy soil taken from the landslide. The initial stress condition acting on a soil element in the sliding surface is applied to the sample. Based on the seismic records monitored at the JR Takarazuka Station, the input seismic wave is synthesized to reproduce the seismic stress acting on the sliding surface. The test results show that the soil failed due to the dynamic loading of the earthquake. The most important results are the excess pore water pressure generation and the acceleration of shear displacement continuing after the main shock. Combined with the grain crushing at the shear zone and the volume reduction in the drained constant-speed ring-shear test, the mechanism of this landslide is interpreted as, shear displacement causing grain crushing in the shear zone and volume reduction, and then resulting in a localized liquefaction phenomenon, "sliding-surface liquefaction". This geotechnical simulation test provides a reasonable interpretation of this highly mobile landslide.

抄録全体を表示