A comparative study of the static and dynamic response of a slope is carried out, using the large deformation theory of the updated Lagrangian formulation and the conventional infinitesimal theory. In the static analysis, a strength reduction method proposed by one of the authors is used to evaluate the safety factor of the slope. It is found that by the large deformation theory, the safety factor is larger than that calculated by the infinitesimal theory, and this difference becomes large along with the reduction of elastic modulus. In the dynamic analysis, it is observed that the large deformation theory gives smaller sliding displacement and larger response acceleration than the infinitesimal approach. It is concluded that in many cases the large deformation approach gives more adequate solutions.

抄録全体を表示

Based on the concept "intermediate soil wedge" which is dependent on mobilized frictional resistance, a new theory has been developed for evaluating the seismic earth pressures against retaining walls under any condition between the active and passive states. For this theory, the seismic earth pressure is separated into four components according to their formation. New equations are proposed to determine the distribution, resultant and point of application for each component. An equivalent seismic coefficient is introduced to take into account non-uniform seismic acceleration distribution with depth. The equations place special emphasis on dependence of the seismic earth pressure on mode and level of wall movement. The equations can be reduced to the Mononobe-Okabe equation for the limiting conditions. Their applicability was confirmed by comparing the predictions with a number of previous model test results.

抄録全体を表示

A finite element model capable of taking into account nonlinear hysteretic soil behavior is presented to study earthquake induced retaining wall movement. The model also accounts for increase in lateral stresses and settlement associated with grain slip caused by cyclic loads. The predictive capability of the proposed method is verified by comparing responses given by the model with those computed by another existing finite element model and also with responses recorded at the Cambridge centrifuge facility. The study reveals that the wall displacement can be substantially affected, among other factors, by the increase in lateral stresses due to grain slip and wall-soil friction. Care should be taken when selecting a constant value of wall-soil friction angle for the entire duration of excitation since structural changes can occur in the soil adjacent to the wall.

抄録全体を表示

During earthquakes, saturated loose sandy soils often liquefy, causing serious damage to buildings and underground structures. Various construction methods have been employed to stabilize these soils against liquefaction. The popular methods are those which increase their density. Vibration and impact methods are commonly employed, but these often pose a problem of noise and vibration in urban areas. Results of previous experiments have shown that Quick Lime Consolidated Briquettes (QCB), a soil stabilizer made of quicklime and cement placed to form cylinders, significantly increases resistance to liquefaction by utilizing the effects of water absorption, swelling, and hardening. In the present study, shaking table tests were performed to evaluate the earthquake resistance of soil treated with QCB. Results of these test showed that the response acceleration and excess pore water pressure in QCB-treated soils were scarcely affected by the excitation of 200 Gals. The soil settlement due to shaking was about one tenth of that for the untreated soil, proving the effectiveness of QCB during earthquakes.

抄録全体を表示

(³H) Tobramycin was used as a probe to determine the relationship between the structure of aminoglycoside antibiotics and their ability to remove this drug from its higher affinity binding site on the ribosome. The dissacharide moieties (neamine, tobramine, gentamine) appeared to have a common binding site, whereas the kanosamine, garosamine and ribose moieties determined the specificity of this binding. Amikacin and butikacin behaved in an anomalous manner in spite of their close structural relationship to tobramycin.

抄録全体を表示

Thermal, dielectric, X-ray and optical investigations of were carried out above room temperature. It was found that undergoes an improper ferroelastic phase transition at 388°C, and has spontaneous strain a_s=(-)/ = 1. × 10-

2

at room temperature.

Tl₂SeO₄

shows domain structures composed of three kinds of orientations with two types of domain boundaries. The crystal belongs to the space group P6₃/mmc with the hexagonal unit cell parameters of a_h=

6

.295(

6

) Å and c_h=

8

.189(

5

) Å at 410°C . It was deduced that the improper ferroelastic phase transition is characterized by the symmetry change from P6₃/mmc to Pnam.

抄録全体を表示

The activities of tobramycin derivatives acetylated and ethylated on the '-N, '-N and 3-N positions were examined. The MICs of these derivatives against tobramycin sensitive strains indicated that '-N-ethylated and '-N-ethylated derivatives have a fairly good activity, and confirmed that the 3-N position is the most important one for antibiotic activity since 3-N derivatives were less active. The MICs of these derivatives against tobramycin resistant strains, and their inactivation by tobramycin modifying enzymes were examined. These results showed that '-N or '-N ethylation protects the drug against inactivation by AAC(') or AAC('), respectively, and '-N-ethyltobramycin and '-N-ethyltobramycin were active against strains containing these modifying enzymes. On the other hand, 3-N ethylation protects the drug against inactivation by AAC(3) but 3-N-ethyl tobramycin does not inhibit strains containing this enzyme.

抄録全体を表示

The objective of this article is to propose and evaluate a sliding-block model to deal with very large displacements of slopes when a horizontal earthquake is applied. The slip surface consists of two inclinations on which full shear resistance is mobilized. Internal shearing exists along a sub-plane that intersects the angle between the two sub-planes that form the external slip surface. The ratio of the distance moved along the two external sub-planes depends on the inclination of the internal sub-plane. If there is a water table line, undrained conditions are assumed during motion and total stress analysis is performed. The governing equations of motion are formulated, analytical solutions are obtained for some cases, and back-analysis of four well-documented slides is performed.

抄録全体を表示

This paper is concerned with an extension of a rotational limit equilibrium method for determining the permanent displacements of slopes under seismic excitation. In the proposed procedure, the sliding mass is treated as a rigid rotating body defined by a log spiral trace. Permanent displacements are obtained by double-integration of the equation of motion in a manner similar to Newmark's translational sliding block method. The seismic slope stability analysis is based on the rotational (variational) limit equilibrium approach. This stability analysis was verified with dynamic experimental results obtained from centrifuge model testing. A series of parametric studies was conducted on"unstable"slopes, investigating the effects of soil properties and characteristics of excitation on the magnitude of permanent displacements. The higher the frictional angle, the smaller the permanent displacement of the slope is. Low excitation frequency yields larger slope displacement if the excitation is extended for the same time period of time. The effect of frequency becomes less distinct when a larger value of yield seismic coefficient is used. The proposed procedures produce a rational criterion to evaluate the seismic performance of simple slopes. This criterion is based on permanent displacement limit rather than factor of safety alone.

抄録全体を表示

  A simple and rapid capillary gas chromatographic (CGC) method with flame ionization detection has been newly developed for analysis of the essential oil from Radix Bupleuri. Twenty components were identified with gas chromatography-mass spectrometry. --heptenal, furan, -pentyl, and --nonenal were quantified simultaneously using the internal standard method. Decane was used as an internal standard. Separation and quantification were achieved on a DB- capillary column (30 m×0.25 mm i. d., 0.25-μm film thickness). The oven temperature was programmed as follows: 60°C to 70°C at 1°C/min rate, 70°C for 10 min, 3°C/min to 120°C, 20°C/min to 250°C, and held at 250°C for min. The oven pressure was programmed as follows: 46.1 kPa for 25 min, 20.0 kPa/min to 77. kPa, and then held for min. Split injection was conducted with a split ratio of 10:1; flow-rate, 1.00 ml/min; carrier gas, nitrogen; injector temperature, 280°C; and detector temperature, 280°C. The system proved effective in resolving --heptenal, furan, -pentyl, and --nonenal peaks from their interfering components. The method displayed excellent linearity in the range of 26.—1072 μg/ml (--heptenal), .—1292 μg/ml (furan, -pentyl), and 7.—1564 μg/ml (--nonenal). The average recovery rates of --heptenal, furan, -pentyl, and --nonenal were 100.3%, 102.%, and %, respectively. CGC is a quick and accurate method for analysis of the essential oil from Radix Bupleuri.

抄録全体を表示

Some existing analytical methods which have been used in geotechnical engineering are modified to handle the shear strength reduction with time due to softening in fissured, over-consolidated clays and mudstones. These are limit equilibrium analysis of slope stability, calculation of earth pressure and calculation of stress and displacement around a tunnel. The softening effect is incorporated in these analyses using the failure criterion and the time-dependent strength parameters proposed previously by the authors. Examples are presented which emphasize the importance of appreciating the softening effect in analyses and further illustrate that the effect of shear strength reduction with time due to softening could easily be captured with existing analytical methods.

抄録全体を表示

Leakage of water due to internal erosion through a dam body or foundation is a major problem with fill-type dams. Recent case histories and research suggest that most cases of internal erosion are possibly triggered by hydraulic fracturing. However, the quantitative mechanism of hydraulic fracturing still remains to be solved. Therefore in-situ hydraulic fracture tests were carried out with a cheap, concise apparatus using boreholes dug in the soft clayey volcanic soil foundation of a low earth dam (Oyachi Dam) in Niigata Prefecture. Water was injected into the foundation through a perforated pipe by two methods : one was under a controlled injection pressure and the other was a controlled injection flow rate. In the former method, the relationship between flow rate and injection pressure was observed and it was found that a yield pressure or fracture pressure existed in all the tests. By repeating the injection test it was confirmed that once a crack is developed, it is very easily reopened by a water pressure a little higher than the earth pressure exerted on the crack. In the latter method, the relationship between injection pressure and time was observed and it was found that fracture pressure varied with flow rate. The boreholes were excavated to observe the development of fracture cracks and it was also found that the cracks had developed perpendicular to the borehole periphery, which means that fracture cracks were induced by tensile stress and denies the explanation that fractures are caused by shear failure.

抄録全体を表示

An analytical measure was developed so that the permanent displacement/deformation caused by seismic subsoil liquefaction can be predicted. Since the effects of topography on displacement is important, a three-dimensional analysis was developed which can fully consider the topography. Moreover, the loss of resistance in the surface unliquefied crust undergoing a tensile stress was taken into account. The empirical interpolation of the lateral displacement along the vertical axis helped reduce the amount of computation. Consequently, a finite-element two-dimensional analysis which is equivalent to a three-dimensional calculation was developed. The displacement obtained by the proposed method is the maximum possible to minimize the potential energy of the subsoil. By comparing the calculated displacement with the observation, the predicted displacement was to some extent greater than the observation. Hence, a dynamic analysis in the time domain, which was also developed by the authors, is necessary for a better matching between prediction and observation. In contrast, the direction of displacement was correctly predicted by the present analysis.

抄録全体を表示

By employing an undrained cyclic loading ring-shear apparatus, a series of tests to reproduce the dynamic behavior of the Nikawa landslide induced by the January 17, 1995 Hyogoken-Nambu earthquake, is conducted. The test sample is Osaka-group coarse sandy soil taken from the landslide. The initial stress condition acting on a soil element in the sliding surface is applied to the sample. Based on the seismic records monitored at the JR Takarazuka Station, the input seismic wave is synthesized to reproduce the seismic stress acting on the sliding surface. The test results show that the soil failed due to the dynamic loading of the earthquake. The most important results are the excess pore water pressure generation and the acceleration of shear displacement continuing after the main shock. Combined with the grain crushing at the shear zone and the volume reduction in the drained constant-speed ring-shear test, the mechanism of this landslide is interpreted as, shear displacement causing grain crushing in the shear zone and volume reduction, and then resulting in a localized liquefaction phenomenon, "sliding-surface liquefaction". This geotechnical simulation test provides a reasonable interpretation of this highly mobile landslide.

抄録全体を表示

This paper provides a comprehensive survey of the numerical methods related to geotechnical problems, most of which were reported in papers appearing in Soils and Foundations. The reason why most of the reviewed papers are concentrated in Soils and Foundations is that if we were to include papers appearing in other journals in the field of geotechnical engineering, closely related to numerical methods, .g., Computers and Geotechnics, Int. J. Numer. Anal. Meth. Geomech., etc., we would have to deal with almost all the papers in those journals. Firstly, we present a description of the current status of the numerical methods, and then give a brief review of the literature covering several topics in geotechnical applications. The scope of the review is limited, and thus, the authors do not profess to cover the entire range of literature.

抄録全体を表示

An empirical equation in use for estimating the pseudo-elastic shear modulus, G_f, of subsoil, associated with shear strains less than 0.001% is proposed in this paper. In a series of in-situ seismic cone tests performed nationwide, the profiles of both G_f and the in-situ void ratio, , with depth were successfully characterised at five sites, each comprising a soft clay layer deposited in the Holocene era. The database which comprised the original data from the field and laboratory tests, coupled with similar information on well-documented Holocene clay deposits in Europe, was statistically analyzed in attempts to determine a generalised relationship with which G_f of soft clay may be reasonably estimated only from routinely available borehole data; that is and the current geostatic effective overburden pressure, σ'_v. An empirical relationship, G_f=, 000 -√(σ'_v) (kPa), was derived from the statistical analysis applied to data from seven different clays worldwide, for which extended over a range between 1 and , and the overconsolidation ratio ranged roughly between 1 and . The applicability of the proposed relationship was evaluated for two case records, each in which the clay exhibited unusual behavior; i.., the undrained shear strength remained more or less constant with depth due to the existence of artesian pressure at one site, and, at the other, G_f decreased, whereas increased, with depth. It was demonstrated that even in these clay deposits exhibiting exceptional profiles, the proposed relationship was capable of predicting G_f with a reasonable accuracy by determining the profiles of and σ'_v with depth. In addition, the prediction when compared to G_max from carefully performed laboratory cyclic tests, yielded a better estimate of G_f from the in-situ seismic survey. Despite the fact that the empirical relationship was initially designated to estimate G_f of soft clays, it may be equally applicable to sandy deposits. This was verified by comparing it to similar, and well-established, relationships developed for sands. A case record as such is also described for a loose sand deposit at Higashi-Ohgishima in Tokyo Bay which was placed in 1960's by land reclamation.

抄録全体を表示