Two new partially saturated tricyclic ring systems, , a, , , , 10, 10a, 11-octahydro-11-oxodibenz [, ] oxepins (a and ), and -thiepins (4a and 4) were synthesized. Compounds 4a and 4 were desulfurized to give a pair of isomeric 2-methylbenzoylcyclohexanes (10a and 10). Deuterated 4a and 4 (11a and 11) were prepared starting from butadiene- (12). The stereochemical features of a (trans), (cis), 4a (trans) and 4 (cis) are compared with those of 10a, 10, 11a and 11 on the basis of proton nuclear magnetic resonance data.

抄録全体を表示

11-Amino-, a, , , , 10, 10a, 11-octahydrodibebenzo[, ]thiepines (a-d) and -oxepines (a-d) were synthesized by the Leuckart reaction of , a, , , , 10, 10a, 11-octahydro-11-oxodibenzo[, ]thiepines (a, )and -oxepines (2a, ) followed by hydrolysis of the reaction products 4a-d and a-d, respectively. The four diastereomers, cis(a-H, 10a-H)-cis(10a-H, 11-H) a and a, cis(a-H, 10a-H)-trans(10a-H, 11-H) and , trans(a-H, 10a-H)-trans(10a-H, 11a-H)c and c, and trans(a-H, 10a-H)-cis(10a-H, 11-H) d and d, were isolated and their configurations and conformations were elucidated by chemical methods together with

1H

-nuclear magnetic resonance spectroscopic and X-ray crystallographic analyses.

抄録全体を表示

The ability of Climacodon septentrionalis to immobilize and kill a mycophagous nematode (Aphelenchoides sp.) in vitro is described for the first time. Two isolates produced droplets (20–45 μm in diameter) that formed at the apices of tall, stalked, and branching secretory cells (700–

,500 μm tall). On 2% modified malt extract agar, nematodes became enveloped in the droplets, which restricted their ability to move and resulted in complete immobilization and death within several hours of contact. The rate of decomposition of the nematodes varied considerably, with most individuals persisting for weeks whereas others were degraded within several days and appeared to be colonized by dense hyphal growth. This study provides the first documentation of a non-agaricoid fungus producing secretory cells that are able to immobilize nematodes.

抄録全体を表示

The possibility of attenuation of microseismic waves due to the presence of an upward folding of the ocean bottom into the liquid is discussed in this paper. The upward folding of the ocean bottom has been idealized by means of an irregularity in the form of a rectangle intruding into the liquid and the evaluation of the displacement component at any point of the solid medium has been carried out in two stages. First, the change in the incident mode of the surface wave due to the presence of the rectangular irregularity has been determined, and second, the subsequent change of the resulting displacement components due to the termination of the liquid layer and the step change in elevation of the solid medium at the continental margin has been discovered. Finally, numerical calculation has been made to determine the attenuation of the microseismic waves of different periods due to the presence of the rectangular irregularity at the ocean bottom.

抄録全体を表示

Natural sedimentary clays exhibit ageing effects on their behaviour when subjected to both consolidation and shearing. Attempts to characterising the in-situ 'structure'of soft marine clays have been made in case studies performed in Ariake (Japan) and in Bangkok (Thailand), each showing a typical profile of aged clay-structure with depth reflecting its site-specific geological consolidation history. In each site, profiles of Atterberg limits, natural water content, overconsolidation ratio (OCR), quasi-elastic shear modulus G_max and the undrained shear strength c_u with depth were attained from various laboratory tests, together with the a comparable profile of quasi-elastic shear modulus from insitu seismic survey G_f. Quantitative assessment of the aged clay-structure was made by using two different measures, metastability index MI (G) and the soil constant reflecting structure S (Jamiolkowski et al., 1994). The profiles of MI (G) and the S-value with depth were both determined based on the corresponding G_max behaviour of the reconstituted sample. "Disturbance"of laboratory samples retrieved by using two different samplers (i.., Laval and Japanese thin-walled samplers) with two different sampling techniques (i.., pre-boring and displacement methods) was discussed. A new approach to estimate c_u"in the ground", termed by the authors the MILK (Metastability Index coupled with Laboratory K_o test) method, is proposed. A trial of the MILK-method is demonstrated in soft Bangkok clay, the texture of which is similar to "soft cheese".

抄録全体を表示

The gamma-ray spectrum and the conversion-electron spectrum are measured in the decay of the ^116mIn activity. Directional correlations are also measured for 818–1293 and 1097–1293 keV cascades. The M-2 mixing ratio δ, and the -2 mixing ratio μ_k are obtained for 818. keV +→2₁⁺ transition to be δ=−+, and μ_k≤.×10⁻⁴ respectively. The 2 branching ratio (2; +→+): (2; +→2₁⁺): (2; +→0₁⁺) is determined to be .0158:.:..

抄録全体を表示

放牧牛において,prostaglandin F_2α(PGF_2α)とestradiol benzoate()の同時筋肉注射による発情同期化効果及び同期化された発情期における受胎性にっいて検討し,次の成績を得た。
.放牧牛31頭(ホルスタイン種未経産牛)において,黄体期にPGF_2α15mgを筋肉注射(A群15頭)あるいはこれと同時に.mgを筋肉注射(群16頭)した結果,処置後31~96時間に発情が発現したものはA群では13頭(.%),群では15頭(93.%)であり,両群の間には大差がなかった。しかし,発情はA群では処置後37~84時間に13頭 (.%),群では31~60時間に14頭(.%)に集中して発現し,の併用によって発情発現までの時間は短縮した。
2.排卵は,A群では処置後73~120時間に13頭(.%),群では61~96時間に14頭(.%)に起こり,の併用によって排卵の時期は処置後早期に,かつ短い時間帯に集中した。
.同期化された発情期に授精したA群の13頭中頭(53.%),群の16頭中頭(56.%)がそれぞれ受胎し,受胎率において両群の間に差異はなかった。
4.以上の成績から,PGF_2αとを同時に併用筋肉注射することは,発情及び排卵の同期化に効果的であることを認めたが,この処置によって同期化された発情期の受胎性については,さらに多数例について検討する必要がある。

抄録全体を表示

The effect of composition and controlled thermomechanical process parameters on the mechanical properties of HSLA steels is modelled using the Widrow-Hoff's concept of training a neural net with feed-forward topology by applying Rumelhart's back propagation type algorithm for supervised learning, using a Petri like net structure. The data used are from laboratory experiments as well as from the published literature. The results from the neural network are found to be consistent and in good agreement with the experimented results.

抄録全体を表示

The phase diagrams of the Ni-Mo- and Ni-W- ternary systems in the region of less than 50mol% were constructed by thermodynamic calculation, based on the data obtained by thermodynamic measurement of the related materials. We found three ternary eutectic points and three or two ternary peritecto-eutectic points as follows:
:L (1365K, 71.mol%Ni-.mol%Mo-.mol%)=(Ni)++
:L (1355K, 62.mol%Ni-2.mol%Mo-30.mol%)=++
:L (1445K, 42.mol%Ni-30.mol%Mo-10.mol%)=(Ni)+NiMo+
:L (1812K, 34.mol%Ni-42.mol%Mo-.mol%)+MoB=+
P₂:L (1633K, 42.mol%Ni-40.4mol%Mo-17.mol%)+Mo=+
:L (1812K, 53.mol%Ni-33.mol%Mo-12.mol%)+Mo=NiMo+
:L (1622K, 51.mol%Ni-31.mol%W-17.4mol%)=(Ni)+W+
:L (1260K, 71.mol%Ni-.mol%W-.mol%)=(Ni)++
:L (1291K, 65.4mol%Ni-4.mol%W-29.mol%)=++
:L (2115K, 23.mol%Ni-43.mol%W-33.mol%)+WB=+
P₂:L (1657K, 48.mol%Ni-33.mol%W-18.mol%)+=W+
The calculated phase diagrams are expected to be useful for the development of new Ni-based heat-, corrosion- or wear-resistance alloys.

抄録全体を表示

Horizontal plate anchors are widely used in civil engineering constructions to resist vertical pulling loads. The available theoretical model suggested by Vesic to estimate the breakout resistance of plate anchors is in significant error, particularly for dense sandy soils. A theoretical model assuming a curved surface of failure through the surrounding soil, to evaluate the ultimate breakout resistance of horizontal plate anchors, has been proposed. It successfully brings out the concept of characteristics relative depth beyond which the breakout factor reaches a constant final value. It is capable of predicting breakout factors for wide range of values of angle of shearing resistance of sand.

抄録全体を表示

It has been shown after mathematical and mechanical investigation that Limit Equilibrium Method (LEM) can be considered as a method to obtain the necessary condition of Slip Line Method (SLM), and that the solution can be obtained under the condition that F_s= and ∂F_s/∂θ=O, where F_s is the safety factor and θ is the inclination of the plane on which the safety factor is defined. Next, the generalized LEM (GLEM) is proposed, dealing with the following points : () Triangular or quadrangular blocks can be treated; (2) Safety factors are defined also on interblock planes; and () All types of plastic problems, slope stability, bearing capacity, and earth pressure are identically formulated. Two situations regarding treatment of the moment equilibrium condition are discussed. GLEM is applied to well-known problems. The results agree well with those obtained by theoretical methods. GLEM can be used to obtain the distribution of earth pressure or bearing capacity. GLEM, Iike ordinary LEM, is very effective for the practical problems, but GLEM is more theoretical and it can result in more accurate solutions.

抄録全体を表示

An unsupervised learning technique and an associative memory have been used for encoding weights by a special type of Petri network named Petri neural net for modelling the influence of alloying elements on the final property of the high strength low alloy steel. The combined effects of alloying elements for different strengthening mechanisms is predicted when weights and threshold values are chosen on the basis of metallurgical understanding. The technique is found to be effective to create an associative memory of input-output relations in unknown data sets so that the same can be subsequently be used as a predictive tool.

抄録全体を表示

Primarily from the point of view of improvement of yield strength due to additions of niobium, titanium and boron in HSLA steels, the experimental steels are divided into five classes. The data are then supplied for learning a Self Organising Map (Kohonen network). It is found that the network with six neurons possesses better capacity of prediction with unknown data. Another effort of clustering the steels according to its major strength contributing mechanisms is also made. But the capacity of the network to cluster unknown data is found to be rather poor and has failed to follow from the metallurgical principles. To avoid this limitation, Learning Vector Quantisation method is adopted to impart a certain amount of supervision in the learning process and it is found that the training pattern of the network attains a good convergence thereby leading to a good predictive ability.

抄録全体を表示

A boron treated copper bearing HSLA steel containing austenite formers like manganese and nickel, somewhat lower in amount than that in HSLA 100 variety of steel is chosen for the study. The role of thermomechanical processing on the microstructure and mechanical properties of the above steel has been investigated. Differential scanning calorimetric study is carried out for understanding the precipitation behaviour of copper in HSLA steel under the influence of boron. The microstructure of the experimental steel is found to consist of laths of martensites and bainite. MA constituents of ribbon like morphology are observed at the lath boundaries. Higher strength properties of the steel are attributed to the presence of finely distributed precipitates of copper and microalloy carbides.

抄録全体を表示

Using two direct introduction methods, DNA synthesis or cell proliferation activities of three purified proteins from . coli, namely, human papillomavirus (HPV) proteins of type 16, a mutant type 16 (24 C-G) (transformation defective) and type , were measured in mouse fibroblast, C127 cells. By a microinjection method, the order of the cell mitotic indexes for the three proteins as determined by -bromo-2'-deoxy-uridine (BrdU) staining was type 16, and 16 (24 C-G). By the osmotic shock method, the

3H

-TdR incorporation and coloration by (

3

-carboxymethoxy phenyl)-2-(4-sulfophenyl)-2H-tetolazorium (MTS) for the three proteins correlated with the pRb binding and focus forming activities previously reported (hunger et al. 1991). These results indicate that the simple osmotic shock method for direct protein introduction may be generally useful for transformation assays of oncoproteins.

抄録全体を表示

By employing an undrained cyclic loading ring-shear apparatus, a series of tests to reproduce the dynamic behavior of the Nikawa landslide induced by the January 17, 1995 Hyogoken-Nambu earthquake, is conducted. The test sample is Osaka-group coarse sandy soil taken from the landslide. The initial stress condition acting on a soil element in the sliding surface is applied to the sample. Based on the seismic records monitored at the JR Takarazuka Station, the input seismic wave is synthesized to reproduce the seismic stress acting on the sliding surface. The test results show that the soil failed due to the dynamic loading of the earthquake. The most important results are the excess pore water pressure generation and the acceleration of shear displacement continuing after the main shock. Combined with the grain crushing at the shear zone and the volume reduction in the drained constant-speed ring-shear test, the mechanism of this landslide is interpreted as, shear displacement causing grain crushing in the shear zone and volume reduction, and then resulting in a localized liquefaction phenomenon, "sliding-surface liquefaction". This geotechnical simulation test provides a reasonable interpretation of this highly mobile landslide.

抄録全体を表示