Sen'i Gakkaishi
Online ISSN : 1884-2259
Print ISSN : 0037-9875
THE EFFECTS OF TENSION IN HEAT SETTING OF NYLON 6 FIBERS
Takeshi Yasuda
Author information
JOURNAL FREE ACCESS

1968 Volume 24 Issue 10 Pages 458-465

Details
Abstract
The effects of the tension in heat setting on the fine structure were studied for nylon 6 fiber. The fine structure is much affected by tension, especially the degree of molecular orientation of amorphous region. The following facts were observed.
The tension in heat setting of nylon 6 fibers has no considerable effect on the degree of crystallinity, whereas it exerts influence on the amorphous region.
Wide angle X-ray diffraction shows a little change in crystallite orientation after heat setting even though much shrinkage occurs.
In the phenol solution of equal concentration, the fibers which the shrink during heat seting swell along fiber axis, though the extended fibers shrink. By this swelling properties, it suggested that some of the molecules in the amorphous region change from the elongated to the folded conformation when the heat is set under zero tension.
The diffusion velocity of dye in fiber becomes very low by tension in heat setting, though the saturated amount of dye at equilibrium does not change greatly. The orientation of molecule in amorphous region is increased remarkably by the tension in the heat set. And the diffusion coefficient of dye in fiber has linear relation to the orientation factor of molecule in the amorphous region.
The tension given in heat setting has very important bearing upon the dye-ability. These results indicate that it is very important to keep tensile condition exact for heat setting process of nylon 6 fiber.
Content from these authors
© The Society of Fiber Science and Technology, Japan
Previous article Next article
feedback
Top