2009 Volume 49 Issue 2 Pages 229-238
The precipitation of nitrides on deoxidation particles in an Fe–10mass%Ni alloy containing 30~130 ppm O and 14~22 ppm N has been studied in the experiments where an alloy was deoxidized with Ti, M (M=Mg, Zr and Ce) and Ti/M at 1600°C and then cooled to 1200°C, followed by holding for 0 and 60 min before quenching. The total number of particles above 0.1 μm remains almost constant except in Ti deoxidation, but the proportion of cubic particles which correspond to nitrides and oxide-nitrides increases during holding at 1200°C in Ti, Zr, Ti/Mg and Ti/Zr deoxidations. In 0.05% (initial amount) Ti deoxidation, the number of TiN and TiN+TiOx particles increases during holding. In 0.03%Ti/0.1%Mg deoxidation, the number of TiOx–TiN particles decreases and the number of MgO–TiN and MgO–Ti(O, N) particles increases during holding due to the reduction of TiOx with soluble Mg. In 0.03%Ti/0.04%Zr deoxidation, the number of ZrO2 particles significantly decreases during holding due to the precipitation of TiN and ZrN on Zr oxides and formation of Zr(O, N)–Ti(O, N) particles. In the cases of Ti/0.08%Zr and Ti/0.12%Ce deoxidations, most of particles at 0 and 60 min of holding are ZrO2 and Zr(O, N) and Ce2O3 oxides, respectively, because the FeO–TiOx oxide in particles is reduced completely by dissolved Zr and Ce.